Abstract:The breakdown and recovery characteristics of the highly repetitive (≤100 kHz) and short nanosecond (∼10 ns) pulsed discharge were investigated. It was found that if one pulse of 40 kV is applied, the air gap between two conical electrodes for a reliable breakdown is only 1 mm; however, if 1000 same pulses are repetitively applied, the longest gap that can be broken down dramatically increases with the increase in the repetitive rate and it reaches 90 mm at 100 kHz. During the preceding pulses that do not cause the breakdown of the gap, long streamers develop from both conical electrodes and nearly bridge the gap, which provides the residual and decaying plasma channels for the rapid breakdown of 90-mm gap in the following pulses, which was experimentally proved to be unique in the extremely non-uniform electric field. The voltage recovery was determined with the two-pulse method and found that the physical processes of the voltage recovery after the short nanosecond pulsed breakdown are similar to that after the microsecond pulsed breakdown, but the time needed for a full recovery in the gas density, in between 50 and 100 μs, is shorter by three orders than that after the microsecond pulsed breakdown. The faster recovery in the gas density may be understood from the small energy of 36 mJ in one nanosecond pulse, which does not induce a high perturbation in the gas density. The evolution in the discharge mode in a 15-mm gap, from corona to diffuse and finally to multichannel spark, with the applied voltage and the repetitive rate was observed. The formation of the multichannel spark is due to the limited energy per pulse that is not enough to heat the primary channel to high conductivity for the collapse of the gap voltage.

Electrical Parameters of a Piezoelectric Transformer-Generated Nanosecond Spark Discharge in Air

Experimental Study of the Electric Pulse-Width Effect on the Acoustic Pulse of a Plasma Sparker

Discharge Characteristic of Nanosecond-Pulse Dbd in Atmospheric Air Using Magnetic Compression Pulsed Power Generator

Nanosecond Repetitively Pulsed Discharge of Point–Plane Gaps in Air at Atmospheric Pressure

Nanosecond-Pulse Gliding Discharges Between Point-To-Point Electrodes in Open Air

Experimental study of atmospheric pressure single-pulse nanosecond discharge in pin-to-pin configuration

Parameterized Nanosecond Pulse Realization Through Parametrical Modulation of Timing Sequence of Switches in Marx Circuit

Pulsed Nanosecond Breakdown Of A Hollow Cathode Discharge With Pseudospark Geometry

Ceramic Piezoelectric Transformer in Vacuum for Acceleration of Electrons and Production of X-Rays

Measurement Of Transient Electric Fields In Air Gap Discharge With An Integrated Electro-Optic Sensor

Study on Dielectric Surface Discharge in Transformer Oil under High Voltage Nanosecond Pulse

Formation of diffuse and spark discharges between two needle electrodes with the scattering of particles

Characteristics of Nanosecond-pulse Dielectric Barrier Discharge in Atmospheric Air

A High Voltage Pulse Power Supply Based on Piezoelectric Transformer

Subnanosecond Electromagnetic Pulse Generated by a Long Spark Discharge: Lightning Implication

Breakdown, Discharge Modes, and Gaseous Recovery of Atmospheric Air with Repetitive 10 Ns Pulses

Measurement of effective energy from a high-voltage spark discharge and its some related problems

Comparison of AC and Nanosecond-Pulsed DBDs in Atmospheric Air

Nanosecond-pulse dielectric barrier discharge using magnetic compression solid-state pulsed power

Initial transient stage of pin-to-pin nanosecond repetitively pulsed discharges in air

Investigation on the Dynamic Process of Gas Breakdown Across Microgaps under Pulsed Voltage