Abstract:Introduction: During warm vertical compaction of gutta-percha, root canal sealers with different chemical compositions absorb the heat generated inside the root canal. The aim of this research was to assess physicochemical modifications of sealers subjected to the System B heat source (Analytic Technology, Redmond, WA) and to evaluate the effect that the use of different sealers has on the heat transfer to the external root surface. Methods: Three proprietary brand sealers (AH Plus [Dentsply International, Addlestone, UK], Pulp Canal Sealer [Kerr Corporation, Orange, CA], MTA Fillapex [Angelus Dental Solutions, Londrina, PR, Brazil]) and a prototype sealer based on Portland cement were assessed. The heat generated on the surfaces of System pluggers and the heat dissipation at different levels (apical, midroot, and cervical) over root surface while using different sealers was assessed using thermocouples. Data were collected in 3 different environmental conditions with the tooth suspended in air, immersed in Hank's balanced salt solution, or gelatinized Hank's balanced salt solution. Chemical changes in the sealers induced by the heat were monitored by Fourier transform infrared spectroscopy. The effect of heat changes on the setting time and compressive strength of the sealers was also assessed. Results: The continuous wave plugger sustained a rise in temperature at a maximum of 80°C at the instrument shank. The highest change in temperature on the external root surface was recorded after 1.5 minutes from the start of heating, and it was restored to body temperature by 6 minutes. Environmental conditions affected heat dissipation for all the sealers in the midroot and cervical regions and the highest increase in temperature (∼60°C) recorded in air. In the midroot and cervical regions, the type of sealer used did not affect the rise in temperature. In the apical region, AH Plus obturations resulted in a greater rise in temperature, and the chemical composition of this sealer was affected by high temperature; it also induced a reduction in sealer setting time and strength. Conclusions: It could be concluded that surrounding conditions, such as temperature and humidity, exerted influence on heating dissipation during the continuous wave of the condensation obturation technique and that root canal sealers presented different conductive/isolating properties. Furthermore, the physical and chemical properties of AH Plus were negatively affected by the changes in temperature.

Evaluation of sealing ability, pH and flow rate of three calcium hydroxide-based sealers.

Physical Properties of 5 Root Canal Sealers

Flow, Filling Ability and Apical Extrusion of New Calcium Silicate-Based Sealers: A Micro-Computed Tomographic Study

Evaluation of the Sealing Ability and Bond Strength of Two Endodontic Root Canal Sealers: An In Vitro Study

Characterization and Assessment of Physical Properties of 3 Single Syringe Hydraulic Cement–based Sealers

Comparative Cytocompatibility and Mineralization Potential of Bio-C Sealer and TotalFill BC Sealer

Chemical, Antibacterial, and Cytotoxic Properties of Four Different Endodontic Sealer Leachates Over Time

Comparative Evaluation of the Sealing Ability of Mineral Trioxide Aggregate (MTA)-Based, Resin-Based, and Zinc Oxide Eugenol Root Canal Sealers: An In Vitro Study

Comparative Evaluation of the Apical Sealability of AH Plus and RealSeal SE Using 5.25% Sodium Hypochlorite with 17% EDTA and 10% Citric Acid as Irrigants-An In Vitro Study

Physicochemical Properties of Epoxy Resin-Based and Bioceramic-Based Root Canal Sealers

Laboratory evaluation of the physicochemical properties of a new root canal sealer based on Copaifera multijuga oil-resin

IN VITRO EVALUATION OF THE Effect of different irrigation solutions on the apical sealing ability of three root canal sealers when the continuous wave obturation technique was used

Investigation of the effect of sealer use on the heat generated at the external root surface during root canal obturation using warm vertical compaction technique with System B heat source

Evaluation of Apical Leakage After Root Canal Obturation with Glass Ionomer, Resin, and Zinc Oxide Eugenol Sealers Combined with Thermafil

[Clinical Effects of Calcium Hydroxide-Based Sealer on Chronic Apical Periodontitis].

In vitro antibacterial activity of endodontic sealers

Field Emission Scanning Electron Microscope Analysis of the Marginal Adaptation of Various Root Canal Sealers at the Dentin-Sealer and Sealer-Guttapercha Interfaces at Three Root Canal Levels: An In Vitro Study

Analysis of the physicochemical properties, cytotoxicity and volumetric changes of AH Plus, MTA Fillapex and TotalFill BC Sealer

A comparative evaluation of two irrigating solutions combination effectiveness on apical sealing of different root canal sealers

Clinical Outcome Evaluation of The Effectiveness of Calcium Hydroxide as A Root Canal Sealer Constituent

Quantitative analysis of endodontic microleakage of 5 different sealers in vitro