Abstract:Capacitor voltage balancing is a critical issue for neutral-point-clamped (NPC)-based converters, including the two-three (2/3)-level dual-active-bridge (DAB) DC-DC converters. The unbalanced capacitor voltage will increase the voltage stress on power devices and negatively affect the reliability of the converters. Two typical problems during the capacitor voltage balancing process should be solved, i.e., power fluctuation minimization and determination of the transformer current polarity. Accordingly, this paper proposes a balancing control scheme based on the complementary-switching-state (CSS) method. In the CSS method, the switching states which are identified to be adverse for balancing will be replaced by their corresponding CSSs to control the neutral-point current while keeping the voltage and current waveforms unchanged. By doing so, the power fluctuation and current overshoot during the balancing process can be significantly reduced. Moreover, since the dynamic voltage and current waveforms are identical to the steady-state waveforms, the transformer current polarity during the balancing process can be identified based on the steady-state power and current models. Therefore, the determination of the transformer current polarity can be simplified compared to the traditional balancing control scheme. Finally, experimental results are carried out to verify the performance of the proposed balancing control scheme.

Modeling and Experimental Validation of Dual-Output Flyback Converters with Capacitive Coupling for Improved Cross-Regulation

Voltage and Current Balancing Control for 48-V Two-Stage Hybrid-Switched-Capacitor Converter

A Synchronous Rectified Flyback AC-DC Converter Using Capacitor-Coupled Isolated Communication

Secondary Side Post Regulation Application in Multiple Output Flyback Converter

A Bidirectional Voltage-Mode Controlled Converter for Power Distribution in a Low-Power Dual-Output Flyback Converter

Capacitor Voltage Balancing for Multilevel Dual-Active-Bridge DC-DC Converters.

Capacitor Voltage Balancing Algorithm with Redundant Level Modulation for a Five Level Converter with Reduced Device Count

Enhancing Power Supply Performance using Parallel Flyback Converters

Three-Output Flyback Converter with Synchronous Rectification for Improving Cross-Regulation and Efficiency

Capacitor Voltage Balancing Control for a Novel 5-Level Dual Active Bridge Converter

Flying Capacitor Double Dual Boost DC-DC Converter

Design Considerations for Dual-Output Quasi-Resonant Flyback LED Driver With Current-Sharing Transformer

Flyback-Based Multiple Output dc-dc Converter with Independent Voltage Regulation

Increasing Efficiency and Power Factor for Power Supplies Using Parallel Flyback Converter

Primary parallel secondary series flyback converter (PPSSFC) with multiple transformers for very high step-up ratio in capacitive load charging applications

Design and Analysis of an Interleaved Flyback–Forward Boost Converter with the Current Autobalance Characteristic

Dynamic Modeling and Controller Design for a Single-Stage Single-Switch Parallel Boost-Flyback–Flyback Converter

A Simple Modulation and Capacitor Voltage Balancing Method for Four-Level Single Flying Capacitor Converters

The Novel Quasi-Resonant Flyback Converter With Autoregulated Structure for Parallel/Serial Input