[Determination of ten bisphenols and five parabens in urine by solid supported liquid-liquid extraction and liquid chromatography-tandem mass spectrometry]
Yu-Fan Xue,Ting Shang,Jun-Tao Cui,Ling-Juan Zhao,Pei Li,Xiang-Ying Zeng,Zhi-Qiang Yu
DOI: https://doi.org/10.3724/SP.J.1123.2024.01001
Abstract:Bisphenols (BPs) and parabens (PBs) are of great concern for environmental pollution and human health because of their endocrine-disrupting effects and potential health hazards. Urinary biomonitoring of BPs and PBs can provide basic data for human internal exposure evaluation, which is a prerequisite for accurately assessing their health risks. In this study, we developed a new pretreatment procedure based on solid supported liquid-liquid extraction (SLE) for the simultaneous separation of ten BPs and five PBs in human urine, followed by high performance liquid chromatography-tandem mass spectrometry (HPLC-MS/MS) analysis. In the instrumental analysis, the HPLC conditions and MS/MS parameters were comprehensively optimized. Accurate qualitative and quantitative determination of ten BPs and five PBs was achieved by introducing a ternary gradient elution system of water, methanol, and acetonitrile for LC separation. During sample pretreatment, the extraction solvent and elution volume were optimized. Specifically, urine samples were held at room temperature and centrifuged at 3000 r/min for 10 min. The supernatant (2 mL) was then transferred to a glass tube, and the pH was adjusted to 5.0 using HCl (0.5 mL; 0.1 mol/L) and NaAc-HAc buffer (1.5 mL). Thereafter, β-glucuronidase-arylsulfatase (20 μL) and surrogate standard solutions (10 ng;13C12-BPS,13C12-BPAF,13C6-MeP, and 13C6-BuP) were added, and the mixture was incubated in a shaker bath in the dark at 37 ℃ for 16 h. After incubation, the hydrolyzed sample (4 mL) was loaded onto an SLE cartridge and equilibrated for a minimum of 5 min to ensure the solution was completely absorbed by the packing material. Subsequently, the target chemicals were eluted with a mixed ethyl acetate/n-hexane solution (3∶7, v/v; 15 mL). Separation of the targets was performed on a ZORBAX SB-C18 reversed-phase column (250 mm×4.6 mm, 5 μm) using an acetonitrile-methanol-water system as the mobile phase. The method was verified by spiking mixed urine samples at three levels (1, 5, and 50 μg/L), with the recoveries ranging from 84.3% to 119.8%. Except for bisphenols (BPS), whose matrix effect was calculated as -21.8%, the matrix effects of other analytes were lower than 20%, indicating low matrix interference. The linear ranges of the analytes varied from 0.1-500 μg/L to 1-500 μg/L, with correlation coefficients higher than 0.995. The method limits of quantification for target chemicals ranged from 0.03 to 0.30 μg/L, and the relative standard deviations of intra- and inter-day experiments were 1.4%-8.4% and 5.7%-14.6%, respectively, suggesting high stability and reproducibility. The method was successfully applied to the determination of ten BPs and five PBs in 10 urine samples from a general population. The concentrations of target chemicals in the human urine samples varied. Methylparaben (MeP), ethylparaben (EtP), propylparaben (PrP), and bisphenol A (BPA) were detected in all samples, with median mass concentrations of 1.10, 0.60, 0.21, and 0.55 μg/L, respectively. The detection rates of the other chemicals were less than 50%, which may be related to the production and use of specific chemicals, their bioavailability, and biological metabolism in humans.