Abstract:The convective drying of spherical biosolids particles from two wastewater treatment plants (Type 1: anaerobic/anoxic treatment with belt filter press dewatering; Type 2: aerobic/anoxic treatment with centrifuge dewatering) was studied under 10 conditions across 44 trials. A wide spectrum of conditions including three drying temperatures (88, 109, and 138 °C ), two gas velocities (1.6 and 2 m s−1 ), and particle sizes of 2 cm and 4 cm were investigated. Measured variables included particle mass, center/internal temperature, surface temperature, shrinkage, and qualitative observations of morphological changes. Most samples showed two drying periods, a constant rate period followed by a falling rate period. Additionally, it was found that drying rates and morphological changes depended significantly on particle size and drying intensity (i.e., drying gas temperature and gas velocity) with higher intensities resulting in larger, more porous particles. Internal temperature profiles displayed a consistent pattern, an initial heating phase where internal temperatures quickly rose to approximately the wet bulb temperature of the drying gas, a quasi-constant temperature phase at that temperature, and a final sharp increase/spike to reach equilibrium with the drying gas temperature. Moreover, IR images showed that sub-surface temperatures (between the core and surface) were significantly lower than surface temperatures. Surface temperatures showed a more linear increase throughout drying until equilibrium with the drying gas temperature. The consistent temperature difference between the center and surface, as well as the internal temperature profile, suggests the existence of a drying front, moving radially inward as the particle dries. This research contributes to a better understanding of biosolids drying dynamics, offering insights to improve thermal treatment strategies thereby contributing to the broader field of waste management.

Thermal efficiency and heat consumption analysis in deep-bed drying

Study on the moisture uniformity of paddy drying technology by employing air direction reversals.

Application of Two-Stage Variable Temperature Drying in Hot Air-Drying of Paddy Rice

Designing the structure and determining the mode characteristics of the grain dryer based on thermosiphons

Comparison of Environmental Pollution and Social Cost Analyses in Different Drying Technologies

Experimental Performance Analysis of a Pilot-Scale Biomass-Assisted Recirculating Mixed-Flow Dryer for Drying Paddy

Modeling and Experimental Study on Drying Characteristics of Corn Particles with Hot Air in Downward Moving Bed

Characteristic analysis of heat loss in multistage counter-flow paddy drying process

Novel Method of Increased Efficiency Corn Drying on a Fixed Bed by Condensation

Experimental and Theoretical Assessment of a Solar Assisted Heat Pump System for In-Bin Grain Drying: A Comprehensive Case Study

Infrared-assisted spouted bed drying of Chinese yam cubes: effect of constant and variable temperature drying processes on drying behavior, uniformity, and quality attributes

Experimental Investigation on a Solar Assisted Heat Pump In-Store Drying System

Internal and surface temperature profiles of spherical biosolids particles during convective drying

Energy Consumption Analysis for High-Temperature and Dehumidification Drying

Study on Drying Characters of a Thin Cotton Fabric under Uneven Radial Heating by the Hot Air Jet

Experimental and numerical study of the airflow distribution in mixed-flow grain dryers

Energy Requisite and Drying Capacity of a Superheated Steam Dryer

Analysis and structure optimization of the flow and temperature fields of the large-scale hot air drying room

Exergy analysis and optimisation of an industrial-scale circulation counter-flow paddy drying process

Temperature Field Simulation and Energy Analysis of a Heat Pump Tobacco Bulk Curing Barn

CFD design and testing of an air flow distribution device for microwave infrared hot-air rolling-bed dryer