Abstract:The evolution of a viscous elliptic vortex ring in an initially quiescent fluid or a linear shear flow is numerically simulated using a lattice Boltzmann method. A wide range of parameters are considered, namely, aspect ratios (AR) (1 ≤ AR ≤ 8), core radius to ring radius ratios (σ0) (0.1 ≤ σ0 ≤ 0.3), Reynolds number (Re) (500 ≤ Re ≤ 3000), and shear rate (K) (0 ≤ K ≤ 0.12). The study aims to fill the gap in the current knowledge of the dynamics of an elliptic vortex ring in a viscous fluid and also to address the issue of whether an elliptic ring undergoes vortex stretching and compression during axis-switching. In a quiescent fluid, results show that for fixed Re and σ0, there exists a critical aspect ratio (ARc), below which an elliptic ring undergoes oscillatory deformation with the period that increases with increasing AR. Above ARc, the vortex ring breaks up into two or three sub-rings after the first half-cycle of oscillation. While higher Reynolds number enhances vortex ring breakup, larger core size has the opposite effect. Contrary to an inviscid theory, an elliptic ring does undergo vortex stretching and compression during oscillatory deformation. In the presence of a linear shear flow, the vortex ring undergoes not only oscillatory deformation and stretching but also tilting as it propagates downstream. The tilting angle increases with the shear rate K and is responsible for inducing a “tail” that consists of a counter-rotating vortex pair (CVP) near the upstream end of the initial major axis after the first half-cycle of oscillation. For a high shear rate, the CVP wraps around the ring and transforms its topological structure from a simple elliptic geometry to a complicated structure that eventually leads to the generation of turbulence.

Vortex simulation of unsteady shear flow induced by a vortex ring

Numerical study of a vortex ring impacting a flat wall

Vortex rings impinging on walls: axisymmetric and three-dimensional simulations

Vortex-to-velocity Reconstruction for Wall-Bounded Turbulence Via the Field-Based Linear Stochastic Estimation

Dynamics and stability of a vortex ring impacting a solid boundary

Evolution of an elliptic vortex ring in a viscous fluid

Dynamics and Instability of A Vortex Ring Impinging on A Wall

Direct numerical simulation of a counter-rotating vortex pair interacting with a wall

Numerical simulation of the interactions between a vortex ring and solid particles suspended above a horizontal wall

Three-dimensional numerical simulation of a vortex ring impinging on a circular cylinder

Instability and disintegration of vortex rings during head-on collisions and wall interactions

Modification of Flow Transition for a Vortex Ring by a Bubble Released at the Axis

An axisymmetric steady state vortex ring model

Flow transitions of head-on vortex ring collisions with contaminated air–water interfaces

Dynamics of the interaction of synthetic jet vortex rings with a stratified interface

Ring Vortex Dynamics Following Jet Formation of a Bubble Expanding and Collapsing Close to a Flat Solid Boundary Visualized via Dye Advection in the Framework of OpenFOAM

Numerical simulation of the postformation evolution of a laminar vortex ring

Vortex Shedding from a Circular Cylinder Near a Moving Wall

Vortex motion around a circular cylinder above a plane

Effects of Wall Wettability on Vortex Flows Induced by Collapses of Cavitation Bubbles: A Numerical Study

Vortex ring pairs: numerical simulation and experiment