Abstract:End-corrosion is typical damage to steel bridge piers, which will reduce the seismic performance. Unlike overall uniform corrosion, end-corrosion results in more complex stresses on bridge piers, however, there are few related studies. This study aims to analyze the mechanical performance of corroded bridge piers and to establish a method for evaluating the seismic damage status of steel piers considering circumferential uniform end-corrosion. Firstly, the effect of corrosion parameters on key performance points of bridge piers is quantitatively analyzed using the validated finite element model. The calculation method of critical displacement value corresponding to different damage states of the end-corroded bridge pier is proposed. A high-precision fiber beam element analysis model is developed to simultaneously consider the effects of end-corrosion and shear stiffness variation. The results show that the degradation degree of yield displacement of the end-corroded bridge pier is relatively small. In contrast, the ultimate displacement, capacity point displacement and bearing capacity are significantly affected by corrosion parameters, and the degradation degree after corrosion can reach more than 30%. The pier damage ratio formula proposed in this study can accurately describe the degradation of the ultimate value, and the calculation error is almost controlled within 15%. The multi-node variable section (MNVS) fiber beam model proposed in this study has higher analysis accuracy, which can be improved by more than 16% compared with the traditional fiber beam model. In addition, the accuracy of the MNVS model in the dynamic analysis is verified by inputting the seismic records under three site conditions. Finally, considering the characteristics of end-corrosion, an evaluation method and procedure for seismic damage status of the steel pier with end-corrosion is established.

Experimental and numerical research on the static behavior of locally corroded OSBD

Probability-Based Performance Degradation Model and Constitutive Model for the Buckling Behavior of Corroded Steel Bars

Effect Of Corroded Surface Morphology On Ultra-Low Cycle Fatigue Of Steel Bridge Piers

Study on Ultra‐low Cycle Fatigue Fracture of Thick‐walled Steel Bridge Piers

Performance Monitoring of Damaged Bridge Members Strengthened with Carbon Fiber Reinforced Polymer

Evaluation of corrosion morphology on mechanical properties of reinforcing steel bars using numerical simulation and simplified analytical model

Monotonic and fatigue behavior of steel-concrete composite beams subjected to corrosion

Fatigue behavior of RD joint in OSBD subjected to local corrosion at top plate

Experimental Investigation and Design of Corroded Stud Shear Connectors

High-Temperature Mechanical Properties of Artificially Simulated Corroded Q500MC Structural Steel

Static and Fatigue Behavior of Steel-Concrete Composite Beams with Corroded Studs

Corrosion-induced Shear Performance Degradation of Reinforced Concrete Beams

Study on Mechanical Properties of Steel-Concrete Composite Beam with Corroded Studs Under the Effect of Negative Bending Moment

Data-driven Corrosion Failure Probabilistic Assessment Model for Reinforced Concrete Structures

Probabilistic fatigue life assessment of bridge welded joints considering steel corrosion

Couple Effect of Loading and Corrosion of Concrete Bridge in Service Life

Compressive Behaviour of Corroded Thin-Walled Circular Section Steel Stub Columns

Non-uniform corrosion influences on mechanical performances of stainless-clad bimetallic steel bars

Performance and damage states assessment of thin-walled steel bridge piers with end-corrosion under earthquake loading

Seismic performance evaluation of steel circular hollow section bridge piers with corroded ends

Experimental Analysis on Strengthening Materials of Orthotropic Steel Bridge Decks