Geometric Solutions for General Actuator Routing on Inflated-Beam Soft Growing Robots

Laura H. Blumenschein,Margaret Koehler,Nathan S. Usevitch,Elliot Wright Hawkes,D. Caleb Rucker,Allison M. Okamura,Laura Blumenschein,Nathan Usevitch,Caleb Rucker
DOI: https://doi.org/10.1109/tro.2021.3115230
IF: 7.8
2021-01-01
IEEE Transactions on Robotics
Abstract:Continuum and soft robots can leverage complex actuator shapes to take onuseful shapes while actuating only a few of their many degrees of freedom. Continuum robotsthat alsogrow increasethe range of potential shapes that can be actuated and enable easier access to constrained environments. Existing models for describing the complex kinematics involved in general actuation of continuum robots rely on simulation or well-behaved stressstrain relationships, but the nonlinear behavior of the thin-walled inflated-beams used in growing robots makes these techniques difficult to apply. Here, we derive kinematic models of single, generally routed tendon paths on a soft pneumatic backbone of inextensible but flexible material from geometric relationships alone. This allows for forward modeling of the resulting shapes with only knowledge of the geometry of the system. We show that this model can accurately predict the shape of the whole robot body and how the model changes with actuation type. We also demonstrate the use of this kinematic model for inverse design, where actuator designs are found based on desired final robot shapes. We deploy these designed actuators on soft pneumatic growing robots to show the benefits of simultaneous growth and shape change.
robotics
What problem does this paper attempt to address?