Abstract:Rectangular explosive charges are usually used in military or civilian explosive transportation and storage. The effects of shape parameters and detonation positions on the peak overpressure and maximum impulse of blasts lack comprehensive investigation, which is significant for the design of blast-resistant structures. In this paper, the side-length ratio of the rectangle, orientation, and detonation position of the charge are chosen as controlling parameters to investigate their influence on blast loads in the scaled distances of the gauges ranging from 0.63 to 10.54 m/kg 1/3 with well validated 3D numerical simulations. The results show that there is a large difference in the near-field spatial distribution of the blast load of the rectangular charge; if the blast load of the rectangular charge is simply evaluated with the spherical charge, the maximum peak overpressure (maximum impulse) will be underestimated by a factor of 7.46 (4.84). This must be taken seriously by blast-resistant structure designers. With the increase in the scaled distance, when the critical scaled distance is greater than 6.32 (7.38) m/kg 1/3 , the influence of the charge shape on the maximum peak overpressure (maximum impulse) of the spatial blast load can be ignored. In general, the impact of detonation of the charge at the end on the maximum peak overpressure is greater compared with central detonation, but for the impact of the maximum impulse, it is necessary to pay attention to the side-length ratio of the rectangular charge and the specific detonation position on the end face. Furthermore, the structural response of steel plates placed at different azimuths under the blast load of a rectangular charge is preliminarily analyzed, and the results show that the deformation and energy of the plates are consistent with the distribution of the blast load. These analysis results provide a reference for the explosion protection design in near-field air explosions.

Incident and Normally Reflected Overpressure and Impulse for Detonations of Spherical High Explosives in Free Air

Probability Distribution and Determination of Blast Loading During Structural Blast Resistant Study

Numerical Estimation of Variation of Pressure and Temperature of Expanding Blast Wave with Time due to Detonation of High Explosives in Air

Propagation characteristics of blast shock waves in low-pressure environment

Numerical Analysis of Blast Behavior for Non-ideal Explosive ANFO in Shock-Tube Test

Study on the characteristics of blast loads due to two simultaneous detonated charges in real air

Numerical Analysis of an Imploding Shock Wave in Solid

Centrifuge Experiment and Numerical Analysis of an Air-Backed Plate Subjected to Underwater Shock Loading

Study on Pressure Reconstruction Method of Explosion Shock Wave

Numerical Simulation of Blast Loads and Dynamic Response of Reinforced Concrete Slab Subjected to Close-in Explosion

Numerical Simulation of Pressure Wave Propagation and Its Effect on Damage to the Reactor Cavity under TNT Detonation for Steam Explosion

Experimental studies of confined detonations of plasticized high explosives in inert and reactive atmospheres

Study on the effect of shape parameters and initiation points of rectangular high explosive on the spatial distribution of blast loads

Geometric Scaling for a Detonation Wave Governed by a Pressure-Dependent Reaction Rate and Yielding Confinement

New approach for calculation of peak over pressure and impulse of aluminized explosive charges

An Approach to Incorporate the Detonation Shock Dynamics into the Calculation of Explosive Acceleration of Metals

Temporally and Spatially Resolved Reflected Overpressure Measurements in the Extreme Near Field

Numerical Simulation and Measurements of Reaction Load for an Impulsively Loaded Pressure Vessel

Mitigation effects on the reflected overpressure of blast shock with water surrounding an explosive in a confined space

Non-parametric characterization of blast loads

Full‐field Peak Pressure Prediction of Shock Waves from Underwater Explosion of Cylindrical Charges