Abstract:The aim of the present study was: development of activated carbon modified with iron (Fe@AC) and modified with iron and zirconium (Fe-Zr@AC) from the Tectona grandis sawdust (TGS) waste biomass and its potential applicability for the removal of As (III) from contaminated water by batch and column mode. The biomass waste was pre-treated with ferric chloride (FeCl3) and the mixture of FeCl3 and zirconium oxide (ZrO2) and then pyrolyzed at 500 °C for 2 h. The properties of both bioadsorbents were comprehensively characterized by using Scanning electron microscopy (SEM), Energy dispersive X-ray (EDX), Fourier transform infra-red spectroscopy (FTIR), X-ray diffraction (XRD), Particle Size analysis (PSA), point of zero charge (pHZPC), Brunauer-Emmett-Teller (BET) to prove successful impregnation of the Fe and Zr on the surface of AC of TGS. FTIR analysis clearly indicates the Fe and Fe-Zr complexation on biosorbents surface and biosorption of As (III). The results revealed that maximum As (III) removal was achieved 86.35% by Fe-Zr@AC (3 g/L dose, pH-7.0, temperature-25 °C and concentration 0.5 mg/L). However, maximum removal of As (III) was attained ~75% by Fe@AC (with dose-4g/L, pH-7.0, temperature-25 °C and concentration 0.5 mg/L) at the initial concentration of 0.5 mg/L of As (III). Fe-Zr@AC exhibits higher efficiency with qmax value 1.206 mg/g than Fe@AC with the qmax value 0.679 mg/g for the removal of As(III). While in the column study, Fe-Zr@AC exhibited 98.8% removal at flow rate of 5 mL/min and bed height of 5 cm. Biosorption Isotherm and Kinetics were fitted good with Langmuir isotherm (R2 ≥ 0.99) and followed pseudo-second-order (R2 ≥ 0.99). The regeneration study indicates that the prepared biosorbents efficiently recycled up to five cycles. Therefore, Fe@AC and Fe-Zr@AC derived from TGS has been showed to be novel, effective, and economical biosorbent. The collective benefits of easy development, good affinity towards As (III), good separability, reusability, and inexpensive of magnetized Fe@AC and Fe-Zr@AC make it a novel biosorbent. The application of Fe-Zr@AC for the removal of As (III) from the water was very efficient its concentration in the solution after treatment was found below the 10 μg/L as per the guideline WHO.

Azadirachta indica Mediated Functionalization of MWCNTs by Ferrites of Nickel and Cobalt for the Remediation of As(III) Ions

Biogenic Synthesis of Nanosized Calcium and Magnesium Ferrites for the Efficient Removal of As+3 ions

Efficient sorption of As(III) from water by magnetite decorated porous carbon extracted from a biowaste material

In-Situ Synthesis of Graphene Oxide/Zinc Ferrite Nanocomposites for As(III) Removal from Aqueous Solution

Superparamagnetic mesoporous ferrite nanocrystal clusters for efficient removal of arsenite from water

Enhanced adsorption of As(V) and Mn(VII) from industrial wastewater using multi-walled carbon nanotubes and carboxylated multi-walled carbon nanotubes

One-Pot synthesis of MWCNTs/Fe-MOFs nanocomposites for enhanced adsorption of As(V) in aqueous solution

Simultaneous removal of arsenate and arsenite in water using a novel functional halloysite nanotube composite

Removal of arsenic from aqueous solution by novel iron and iron-zirconium modified activated carbon derived from chemical carbonization of Tectona grandis sawdust: Isotherm, kinetic, thermodynamic and breakthrough curve modelling

Efficient removal of As(III) via simultaneous oxidation and adsorption by magnetic sulfur-doped Fe-Cu-Y trimetal oxide nanoparticles

As(III) removal from aqueous solutions using simultaneous oxidation and adsorption process by hierarchically magnetic flower-like Fe3O4@C-dot@MnO2 nanocomposite

Efficiency of a novel nitrogen-doped Fe3O4 impregnated biochar (N/Fe3O4@BC) for arsenic (III and V) removal from aqueous solution: Insight into mechanistic understanding and reusability potential

Arsenic removal from water by nanometer iron oxide coated single-wall carbon nanotubes

Efficient Removal of Cr (VI) and As (V) from Aqueous Solution Using Magnetically Separable Nickel Ferrite Nanoparticles

Mussel inspired functionalization of carbon nanotubes for heavy metal ion removal

Multi-Walled Carbon Nanotubes Functionalized with Hydroxamic Acid Derivatives for the Removal of Lead from Wastewater: Kinetics, Isotherm, and Thermodynamic Studies

Ferrous Magnetic Nanoparticles for Arsenic Removal from Groundwater

Biosynthesis and Analytical Characterization of Iron Oxide Nanobiocomposite for In-Depth Adsorption Strategy for the Removal of Toxic Metals from Drinking Water

A novel nanocomposite of aminated silica nanotube (MWCNT/Si/NH2) and its potential on adsorption of nitrite

Removal of Pb2+ ions from synthetic wastewater using functionalized multi-walled carbon nanotubes decorated with green synthesized iron oxide–gold nanocomposite

MOFs-derived Magnetic Chestnut Shell-Like Hollow Sphere NiO/Ni@C Composites and Their Removal Performance for Arsenic(v)