Abstract:The rheo-dielectric response of carbon black filled elastomer melts is investigated by dielectric relaxation spectroscopy in the frequency range from 0.1 Hz up to 10 MHz during oszillatory shearing in a plate-plate rheometer. Various concentrations and types of carbon blacks dispersed in a non-crosslinked EPDM melt are considered. It is demonstrated that during heat treatment at low strain amplitude a pronounced flocculation of filler particles takes place leading to a successive increase of the shear modulus and conductivity. Followed up by a strain sweep, the filler network breaks up and both quantities decrease simultaneously with increasing strain amplitude. Two relaxation times, obtained from a Cole-Cole fit of the dielectric spectra, are identified, which both decrease strongly with increasing flocculation time. This behaviour is analyzed in the frame of fractal network models, describing the effect of structural disorder of the conducting carbon black network on the diffusive charge transport. Significant deviations from the predictions of percolation theory are observed, which are traced back to a superimposed cluster-cluster aggregation process (CCA). During flocculation, a universal scaling behaviour holds between the conductivity and the corresponding high frequency relaxation time, which fits all the measured data. The scaling exponent agrees fairly well with the prediction obtained from CCA. It is demonstrated that the underlying basic mechanism is a change of the correlation length of the filler network, i.e. the size of the fractal heterogeneities. This decreases during flocculation due to the formation of additional conductive paths, making the system more homogeneous. An addition less pronounced effect is found from nanoscopic gaps between adjacent filler particles, which decrease during flocculation. The same universal scaling behaviour, as obtained for flocculation, is found for temperature-dependent dielectric measurements of the cured crosslinked systems, which are heated from room temperature up to 200 °C. Thereby, the conductivity decreases significantly and the relaxation time increases, indicating that the filler network breaks up randomly due to the thermal expansion of the rubber matrix.

Assessing robustness of hyperelastic models for describing nonlinearity of the mechanical response for pristine and swollen carbon black filled elastomers

Mechanical Behaviors of Copolymer Elastomers: Experimental Characterization and Constitutive Modelling

A Molecular Study on the Reinforcement of Polymethylene Elastomers

Network Alteration of Cyclically Loaded Elastomers Mediated by Dynamic Bonds

Mesoscale models for effective elastic properties of carbon-black/ultra-high-molecular-weight-polyethylene nanocomposites

Tension responses of carbon black filled rubbers at intermediate and high strain rates: Experimental investigation and modeling

Three-dimensional numerical simulations on the hyperelastic behavior of carbon-black particle filled rubbers under moderate finite deformation

A hyper-viscoelastic constitutive model for elastomers: A case study of hydrogenated nitrile butadiene rubber and polychloroprene rubber

Study of the Effect of Carbon Black Filling on the Mechanical Behavior of Rubber Hyper-Elasticity

A physically-based damage model for soft elastomeric materials with anisotropic Mullins effect

Experimental Investigation and Constitutive Modeling of Uncured Carbon Black Filled Rubber at Different Strain Rates

Carbon black networking in elastomers monitored by simultaneous rheological and dielectric investigations

Experiments and modeling of the coupled viscoelasticity and Mullins effect in filled rubber materials

Microstructure effect analysis of carbon black-filled rubber composites

Investigation of Rheological, Mechanical, and Viscoelastic Properties of Silica-Filled SSBR and BR Model Compounds

Effects of Large Deformation and Velocity Impacts on the Mechanical Behavior of Filled Rubber: Microstructure-Based Constitutive Modeling and Mechanical Testing

Finite viscoelasticity of filled rubbers: experiments and numerical simulation

Stress and Resistance Relaxation for Carbon Nanoparticle Silicone Rubber Composite Large-Strain Sensors

Molecular dynamics simulation of the impact of the surface topology of carbon black on the mechanical properties of elastomer nanocomposites

A simple Solvable Model of Body Motion in a One-dimensional Resistive Medium

Deformation of Elastomeric Networks: Relation between Molecular Level Deformation and Classical Statistical Mechanics Models of Rubber Elasticity