Abstract:The modern compressor operation is challenged by the liquid presence in wet gas operating conditions. The liquid phase may affect the compressor stability by partially flooding the internal annular gas seals and inducing subsynchronous vibration (SSV). To improve the annular seal behavior and increase the rotor stability, high-precision results of leakage flow rates and rotordynamic force coefficients are needed for annular gas seals in wet gas conditions. In order to better understand the leakage and rotordynamic characteristics of the annular gas seal in wet gas conditions, a 3D transient CFD-based perturbation method was proposed for computations of leakage flow rates and rotordynamic force coefficients of annular gas seals with liquid phase in main gas phase, based on inhomogeneous Eulerian-Eulerian multiphase flow model, mesh deformation technique, and the multifrequency rotor whirling orbit model. Numerical results of frequency-dependent rotordynamic force coefficients and leakage flow rates were presented and compared for three types of noncontact annular gas seals, which include a smooth plain annular seal (SPAS), a labyrinth (LABY) seal, and a fully partitioned pocket damper seal (FPDS). These three seals were designed to have the identical rotor diameter, sealing clearance, and axial length. The accuracy and the availability of the present transient CFD numerical method were demonstrated with the experiment data of leakage flow rates and frequency-dependent rotordynamic force coefficients of the smooth plain seal with four inlet liquid volume fractions (LVFs) of 0%, 2%, 5%, and 8%. Steady and transient numerical simulations were conducted at inlet air pressure of 62.1 bar, pressure ratio of 0.5, rotational speed of 15,000 rpm, and inlet preswirl ratio of 0.3 for four inlet LVFs varying from 0% to 8% and 14 subsynchronous and synchronous whirling frequencies up to 280 Hz. The numerical results show that the inlet liquid phase has a significant influence on the leakage and rotordynamic coefficients for all three types of annular gas seals. The mixture leakage flow rate increases with the increasing inlet LVF, combining the decreasing gas-phase and linearly increasing liquid-phase leakage flow rates. The smooth plain seal leaks the most gas phase and liquid phase, followed by the pocket damper seal (PDS) and then the labyrinth seal. Increasing inlet LVF significantly decreases the direct stiffness and slightly increases the effective damping of the smooth plain seal. The labyrinth seal possesses evident negative direct stiffness and shows a noticeable decreasing effective damping with the increasing inlet LVF at the subsynchronous frequency range. Increasing inlet LVF obviously increases all the force coefficients of the pocket damper seal including the positive effective damping. From a rotordynamic viewpoint, the FPDS possesses a better liquid tolerant capability and so is a better sealing scheme for the balance piston seals and center seals of the centrifugal compressor in wet gas operating condition.

Experimental Study on the Coefficient of Internal Frictional Resistance in the Annular Gap during the Plunger Gas Lift Process

Study on Friction Characteristics of Slipper Pair of Large Displacement High-Pressure Piston Pump

Gas-liquid Flow Seal in the Smooth Annulus During Plunger Lifting Process in Gas Wells

Analysis of Friction Characteristics of Pneumatic Cylinders Based on LuGre Model

Experiment on friction characteristics of pneumatic cylinders base on LuGre model

Transient Liquid Leakage During Plunger Lifting Process in Gas Wells

A physical model for liquid leakage flow rate during plunger lifting process in gas wells

Study on Annular Pressure Buildup in Offshore Heavy Oil Thermal Recovery Wells Considering Dissolved Gas Contained in Annuli

Interfacial friction effects on sealing performances of elastomer packer

Applicability evaluation of plunger lift technology in shale gas wells

Numerical Investigation on the Leakage and Rotordynamic Characteristics for Three Types of Annular Gas Seals in Wet Gas Conditions

Gas Migration Model for Non-Newtonian Fluids Under Shut-In Well Conditions

Study on the Flow Pattern and Transition Criterion of Gas-Liquid Two-Phase Flow in the Annular of Shale Gas Fractured Horizontal Wells

Experimental Research on the Transformation of Gas-Oil Two-Phase Flow Pattern in Large Vertical Annulus

Modeling fluctuating pressure in the eccentric annulus with a four-parameter rheological method

Research on the influence of strike-slip fault slippage on production casing and control methods and engineering application during multistage fracturing in deep shale gas wells

Experimental study on the controlling factors of frictional coefficient for lost circulation control and formation damage prevention in deep fractured tight reservoir

Hydraulic Effects of Drill-String Tool Joint and Rotation on Annular Flow Profile and Frictional Pressure Loss Using ANSYS-CFX

Cuttings-liquid frictional pressure loss model for horizontal narrow annular flow with rotating drillpipe

Zero-Net Liquid Flow Simulation Experiment and Flow Law in Casing Annulus Gas-Venting Wells

Experimental and Modeling Investigation on Gas-Liquid Two-Phase Flow in Horizontal Gas Wells