Abstract:To clarify the evolution of thermal maturity and pore structure in continental organic-rich shales, calcareous shales of the Liaohe Basin (China) were pyrolyzed, and examined using Raman spectroscopy, Fourier transform infrared spectroscopy (FTIR), X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS), scanning electron microscopy (SEM), nitrogen sorption isotherms, and nuclear magnetic resonance (NMR) spectroscopy. The increase in Raman G‒D band separation and decrease in Raman I D /I G ratio with increasing thermal maturity indicate that these parameters provide superior thermal maturity indicators. This is also confirmed by the good linear correlation of G‒D band shifts and I D /I G with vitrinite reflectance (VR) and maximum temperature (T max ), respectively. The relative detection accuracy (DA), sampling requirements (SR), sample preparation (SP), detection time (DT), and equipment requirement (ER) of VR, G‒D band shifts, I D /I G , T max , FTIR, and XPS indicate that Raman analysis is a simple, quick, and robust method to evaluate thermal maturity. The moderate SR, complex SP, and long DT suggest that VR and T max are less widely applicable for characterizing thermal maturity. The FTIR and XPS techniques provide semi-quantitative maturity indicators with poor DA and high ER. Pores observed within organic matter and minerals under SEM indicate that an increase in thermal maturity not only affects the development of organic pores but is also beneficial for the formation of mineral dissolution pores, such as those formed during the transformation of Na 0.95 Ca 0.16 Al 1.16 Si 2.84 O 8 to Na 0.84 Ca 0.02 Al 1.02 Si 2.98 O 8 , a process confirmed by XRD. The BET and NMR data also indicate that the development of pore structure is closely related to the evolution of thermal maturity in calcareous shale. During the initial stage, primary pores are filled by bitumen generated from kerogen; this leads to a decrease in transition pores, mesopores, and shale porosity, and reduced pore connectivity. Then, secondary nanoscale pores, transition pores, and mesopores increase with increasing thermal maturity. The peak in secondary porosity is consistent with the liquid hydrocarbon production rate peak, a process that increases shale porosity and leads to improved pore connectivity. The dissolution of minerals induced by organic acids may also contribute to this secondary porosity. With a further increase in thermal maturity, secondary porosity at the microscale is further developed, while transition pores and mesopores collapse, resulting in reduced pore connectivity. The poor pore connectivity that occurs at both low and high VR values may be more conducive to the preservation of shale oil and gas. This study is significant for research into the evolution of thermal maturity and pore structure in continental organic-rich shales.

Characterization of free and bound bitumen fractions in a thermal maturation shale sequence. Part 2: Structural evolution of kerogen and bitumen during shale oil generation, expulsion and retention

Characterization of Free and Bound Bitumen Fractions in a Thermal Maturation Shale Sequence. Part 1: Acidic and Neutral Compounds by Negative-Ion ESI FT-ICR MS

Impact of thermal maturity on the diagenesis and porosity of lacustrine oil-prone shales: Insights from natural shale samples with thermal maturation in the oil generation window

Nanoscale Pore Network Evolution of Xiamaling Marine Shale during Organic Matter Maturation by Hydrous Pyrolysis

Multifractal Methods in Characterizing Pore Structure Heterogeneity During Hydrous Pyrolysis of Lacustrine Shale

Microstructural Imaging and Characterization of Oil Shale Before and after Pyrolysis

Pyrolysis of an organic-rich shale containing type II kerogen before and after oil generation and expulsion: Implications for the generation of late hydrocarbon and hydrogen gases

The Characteristics of Bound Biomarkers Released from Asphaltenes in a Sequence of Naturally Biodegraded Oils

Characterization of the evolution of thermal maturity and pore structure of continental organic-rich shales

Structural characterization of thermal bitumen extracted from Fushun oil shale semi-coke with ionic liquid/N-methyl pyrrolidone

Chemical Structure Changes of Lacustrine Type-II Kerogen under Semi-Open Pyrolysis As Investigated by Solid-State 13C NMR and FT-IR Spectroscopy

The relationship between oil generation, expulsion and retention of lacustrine shales: Based on pyrolysis simulation experiments

Evaluation of Hydrocarbon Generation of the Xiamaling Formation Shale in Zhangjiakou and Its Significance to the Petroleum Geology in North China

Evaluation of solid bitumen created from marine oil shale bituminite under hydrous and anhydrous pyrolysis conditions

Distribution and occurrence of pore water and retained oil in nanopores of marine-terrestrial transitional shales during oil generation and expulsion: Implications from a thermal simulation experiment on shale plug samples

Hydrocarbon generation from lacustrine shales with retained oil during thermal maturation

Hydrocarbon Generation Mechanism of Mixed Siliciclastic–Carbonate Shale: Implications from Semi–Closed Hydrous Pyrolysis

Potential of Light Oil and Condensates from Deep Source Rocks Revealed by the Pyrolysis of Type I/II Kerogens after Oil Generation and Expulsion

Multicomponent Shale Oil Flow in Real Kerogen Structures via Molecular Dynamic Simulation

Maceral evolution of lacustrine shale and its effects on the development of organic pores during low mature to high mature stage: A case study from the Qingshankou Formation in northern Songliao Basin, northeast China

Kinetic modeling of Kukersite oil shale pyrolysis with thermal bitumen as an intermediate