Abstract:Traditional machine learning methods assume that training and testing data must be from the same machine running condition (MRC) and drawn from the same distribution. However, in several real-time industrial applications, this assumption does not hold. The traditional methods work satisfactorily in steady-state conditions but fail in time-varying conditions. In order to utilize time-varying data in variable MRCs, this article proposes a novel low-level knowledge transfer framework using a deep neural network (DNN) model for condition monitoring of machines in variable running conditions. The low-level features have been extracted in time, frequency, and time–frequency domains. These features are extracted from the source data to train the DNN. The trained DNN-based parameters are then transferred to another DNN, which is modified according to the low-level features extracted from the target data. The proposed approach is validated through three case studies on: 1) the air compressor acoustic data set; 2) the Case Western Reserve University bearing data set; and 3) the intelligent maintenance system bearing data set. The prediction accuracy obtained for the above case studies is as high as 100%, 93.07%, and 100%, respectively, with fivefold cross-validation. These real-time results show considerable improvement in the prediction performance using the proposed approach. Note to Practitioners—Condition-based monitoring schemes are widely applicable to rotating machines in various industries since they operate in tough working situations, and consequently, unpredicted failures occur. These unpredicted failures may cause perilous accidents in the industries. CBM systems prevent such failures, which results in the reduction of equipment damage and, hence, increases machinery lifetime. Modern industries are so complex and generating huge -ata, and these data can be collected using sensors, but placing a large number of sensors is difficult and expensive for different but similar kinds of faults in industries. This also increases the cost due to additional sensors and circuits. In this article, the authors have proposed a novel low-level knowledge transfer framework using the deep neural network (DNN)-based method for condition monitoring of machines in variable running conditions. Low-level features have been extracted to reduce the computations of DNN drastically with improved performance. This article also considered additional faults in the target domain, which is more practical in real-time applications. The proposed scheme has been validated with three case studies on acoustic and vibration signatures.

Fully interpretable neural network for locating resonance frequency bands for machine condition monitoring

New statistical learning perspective for design of a physically interpretable prototypical neural network for machine condition monitoring

Machining Vibration States Monitoring Based on Image Representation Using Convolutional Neural Networks.

Interpreting network knowledge with attention mechanism for bearing fault diagnosis

An interpretable multiplication-convolution residual network for equipment fault diagnosis via time–frequency filtering

Deep Neural Network-Embedded Stochastic Nonlinear State-Space Models and Their Applications to Process Monitoring

Large margin-learning methodology from time-frequency maps and its physically interpretable weights for simultaneous machine health monitoring and fault diagnosis

An Interpretable Model for ECG Data Based on Bayesian Neural Networks

Gaussian assumptions-free interpretable linear discriminant analysis for locating informative frequency bands for machine condition monitoring

Intelligent Condition Monitoring with CNN and Signal Enhancement for Undersampled Signals

Neural Networks and Fuzzy Data Fusion for Machine Condition Monitoring

Transparent Operator Network: A Fully Interpretable Network Incorporating Learnable Wavelet Operator for Intelligent Fault Diagnosis

Exploring the Efficiencies of Spectral Isolation for Intelligent Wear Monitoring of Micro Drill Bit Automatic Regrinding In-Line Systems

Interpretability of deep convolutional neural networks on rolling bearing fault diagnosis

Integration of a Novel Knowledge-Guided Loss Function With an Architecturally Explainable Network for Machine Degradation Modeling

A neural network constructed by deep learning technique and its application to intelligent fault diagnosis of machines

A Neural Network for High-Precise and Well-Interpretable Electrocardiogram Classification

A novel ResNet-based model structure and its applications in machine health monitoring

Condition-Based Monitoring in Variable Machine Running Conditions Using Low-Level Knowledge Transfer With DNN

Interpretable parallel channel encoding convolutional neural network for bearing fault diagnosis

An Interpretable Multiplication-Convolution Network for Equipment Intelligent Edge Diagnosis