Abstract:Grain boundaries (GBs) are known to have an important influence on material properties, so understanding how GBs in graphene change its physical properties is important both scientifically and technologically. In this paper, we perform a series of molecular dynamics simulations to investigate the energies, mechanical properties and fracture process of 29 graphene GBs (symmetric and nonsymmetric) under tensile strains. With different arrangements of the pentagonal and heptagonal rings, the misorientation angle () ranges from 3.5 to 27.8. The GBs defects in graphene can produce a pre-strain that will lead to an increase of the energy of GBs. We study the atomic energy distribution around GBs and define a new parameter: single defect energy (Esingle) to calculate the average energy per GBs defect. It is found that Esingle shows a clear linear relation between and defect density (), because pre-strain filed can be cancelled out locally with the increase of defect density. And this pre-stain can reduce the strength of the C-C bond contained in GBs defects. Hence, with very few exceptions, mechanical failure always starts from the defective region. Furthermore, the energy of GBs can be used to reflect the strength of GBs indirectly. The simulated results show that the tensile strength of GBs is linearly related to the highest atomic energy (Emax), and it also depends on Esingle monotonically. Owing to the pre-strain, load distribution along GBs is uneven. Because some bonds are stretched while others are compressed, that is, the real number of bearing carbon bonds is less than the nominal number. Therefore, at the beginning of tension, the Young's modulus of polycrystalline graphene is significantly lower than that of the monocrystal one. But with the increase of strain, it becomes comparable to that of the monocrystal graphene at sufficiently large strain. The results of fracture process indicate that formation and propagation of crack are both dependent on strength GBs. For low GB strength, the fracture mechanism is transgranular fracture in the form of direct fracture of C-C bonds. When stress reaches a critical value, the weakest C-C bonds in GBs will breakdown and form a fracture site. Because of the uneven bearing condition, the C-C bonds in front of the crack possess considerable residual strength and could prevent crack from propagating. As a result, many other fracture sites in the GBs defect can be produced with the increase of strain, and finally, these sites emerge gradually along GBs and form a sawtooth crack. In contrast, the fracture process of high strength GBs is always accompanied with the variations of Stone-Wales (S-W) transformation and direct fracture of C-C bonds. Once the fracture site forms, the crack will propagate rapidly predominantly along armchair or zigzag direction and finally could cross GBs, this process can be called intergranular fracture. Our present work provides fundamental guidance for understanding how defects affect the mechanical behaviour, which is important for further research and application of graphene devices.

Temperature-dependent mechanical properties and the microscopic deformation mechanism of bilayer γ-graphdiyne under tension

Two-dimensional Graphene Heterojunctions: the Tunable Mechanical Properties

Graphdiyne Family-Tunable Solution to Shock Resistance

Mechanical and Thermal Properties of Graphyne-Coated Carbon Nanotubes: a Molecular Dynamics Simulation on One-Dimensional All-Carbon Van Der Waals Heterostructures

N-graphdiyne Two-Dimensional Nanomaterials: Semiconductors with Low Thermal Conductivity and High Stretchability

Mechanical Properties of Hydrogen Functionalized Graphyne - A Molecular Dynamics Investigation

Temperature and Strain-Rate Effects on the Deformation Behaviors of Nano-Crystalline Graphene Sheets

Yielding and jerky plasticity of tilt grain boundaries in high-temperature graphene

Investigation of Deformation and Fracture Mechanisms in Two-dimensional Gallium Telluride Multilayers Using Nanoindentation

Unusual Deformation and Fracture in Gallium Telluride Multilayers

Molecular Dynamics Study of the Tensile Mechanical Properties of Polycrystalline Graphene

Temperature-dependent brittle-ductile transition of α-graphyne nanotubes under uniaxial tension

Effects of Grain Size, Temperature and Strain Rate on the Mechanical Properties of Polycrystalline Graphene – A Molecular Dynamics Study

The Effects of Morphology and Temperature on the Tensile Characteristics of Carbon Nitride Nanothreads.

In-plane and Interlayer Mechanical Behaviors of Diamane Superlattice Generated in Twisted Bilayer Graphene

Molecular Dynamics Simulation of Interfacial Mechanical Behavior of Multilayer Graphene

Structural and electronic properties of bilayer and trilayer graphdiyne.

Mechanical Properties of Graphynes under Shearing and Bending

Principles and Mechanisms of Strain-Dependent Thermal Conductivity of Polycrystalline Graphene with Varying Grain Sizes and Surface Hydrogenation

Graphullerene: a fully atomistic analysis of the tensile characteristics under temperature variation

Temperature Dependence of Interfacial Bonding and Configuration Transition in Graphene/Hexagonal Boron Nitride Containing Grain Boundaries and Functional Groups