Abstract:The elimination of the need for an Ohmic heating solenoid may be the most impactful design driver for the realization of economical compact fusion tokamak reactor systems. However, this would require fully non-inductive start-up and current ramp-up from zero plasma current and low electron temperature of sub-keV to the full plasma current of ~ 10 - 15 MA at 20 - 30 keV electron temperature. To address this challenge, an efficient solenoid-free start-up and ramp-up scenario utilizing a low-field-side-launched extraordinary mode at the fundamental electron cyclotron harmonic frequency (X-I) is proposed, which has more than two orders of magnitude higher electron cyclotron current drive (ECCD) efficiency than the conventional ECCD for the sub-keV start-up regime. A time dependent model was developed to simulate the start-up scenarios. For the Spherical Tokamak Advanced Reactor (STAR) [1], it was found that to fully non-inductively ramp-up to 15 MA, it would take about 25 MW of EC power at 170 GHz. Because of the relatively large plasma volume of STAR, radiation losses must be considered. It is important to make sure that high Z impurities are kept sufficiently low during the early current start-up phase where the temperature is sub-keV range. Since the initial current ramp up takes place at a factor of ten lower density compared to the sustained regimes, it is important to transition into a higher bootstrap fraction discharge at lower density to minimize the ECCD power requirement during the densification. For the sustainment phase an array of eight gyrotron launchers with a total of about 60 MW of fundamental O-mode was found to be sufficient to provide the required axis-peaked external current drive. High efficiencies between 19 – 57 kA/MW were found with optimal aiming, and these were resilient to small changes in aiming angles and density and temperature profiles.

The Optimisation Of The Step Electron Cyclotron Current Drive Concept

Dynamic Optimization of Open-Loop Input Signals for Ramp-Up Current Profiles in Tokamak Plasmas

Dynamic Optimization Of Tokamak Plasmas Via Control Parameterization And The Time-Scaling Transformation

Ramp-Up-Phase Current-Profile Control of Tokamak Plasmas Via Nonlinear Programming

Dynamic Optimization of Trajectory for Ramp-Up Current Profile in Tokamak Plasma

Design and Simulation of Extremum-Seeking Open-Loop Optimal Control of Current Profile in the DIII-D Tokamak

Extremum-Seeking-Based Receding-Horizon Optimal Control of Plasma Current Profile in the DIII-D Tokamak

Receding-horizon optimal control of the current profile evolution during the ramp-up phase of a tokamak discharge

Optimal Tracking Control of Current Profile in Tokamaks

Control of Ramp-Up Current Profile Dynamics in Tokamak Plasmas Via the Minimal-Surface Theory

Finite Element Approximation and Input Parameterization for the Optimal Control of Current Profiles in Tokamak Plasmas

Efficient ECCD non-inductive plasma current start-up, ramp-up, and sustainment for an ST fusion reactor

Poloidal Magnetic Flux Profile Control in Tokamaks Via Normalized Coprime Factorization Robust Control

Improved Tokamak Concept Focusing On Easy Maintenance

Data-Driven Modeling and Feedback Tracking Control of the Toroidal Rotation Profile for Advanced Tokamak Scenarios in Diii-D

Closed-Loop Tracking Control Of Poloidal Magnetic Flux Profile In Tokamaks

Optimisation of the poloidal field system for advanced divertor configurations in STEP

Plasma burn—mind the gap

Conceptual design workflow for the STEP Prototype Powerplant

Managing the heat: In-Vessel Components

Development and Optimization of Step-A Linear Plasma Device for Plasma-Material Interaction Studies