Microwave-assisted KOH activated lignite semi-coke for treatment of biologically treated wastewater from pulp and paper mill

Zhuqing Feng,Huilun Chen,Haiqing Li,Rongfang Yuan,Fei Wang,Zhongbing Chen,Beihai Zhou

DOI: https://doi.org/10.1016/j.jece.2020.103924

IF: 7.7

2020-08-01

Journal of Environmental Chemical Engineering

Abstract:<p>In view of the urgent need to treat biologically treated wastewater from pulp and paper mill (BTW) and the high cost of commercial activated carbon, microwave-assisted KOH activated lignite semi-coke (MLSC) was prepared for adsorption of BTW. Through the research, the best preparation conditions of MLSC are obtained (ratio of KOH/lignite semi-coke (LSC) = 1, radiation time 10 min, and microwave power 700 W). In order to further study the effect of microwave power, three kinds of MLSC were prepared under the conditions of 600 W (MLSC-600), 700 W (MLSC-700) and 800 W (MLSC-800), and a series of characterizations were performed. The research of coupled thermogravimetric and mass spectrometer system showed that KOH impregnated LSC produced hydrogen during pyrolysis, which proved that activation reaction took place between KOH and LSC. And pore characteristics study found that most of the pore size of MLSC was less than 0.7 nm, and MLSC-700 had finer micropores (0.6 nm&lt;<em>Ø</em>&lt;0.65 nm). The adsorption experiment showed that MLSC-700 had the best adsorption effect, the removal rates of COD and TOC can reach 96 % and 80 %. The Langmuir model and Elovich kinetic model can be used to fit adsorption isotherms and kinetics, respectively. It was found that due to the microporous structure of MLSC, the removal rate of low molecular weight pollutants (0−4500 Da) contained in BTW is very high. The microporous MLSC-700 prepared in this study is suitable for BTW treatment.</p>

engineering, chemical, environmental