Abstract:Electron diffusion thermopower is the dominant item in conventional thermoelectric materials. In magnetic ferromagnetic Co‐based full Heusler alloys, spin fluctuation and magnon drag make a great contribution to thermopower far larger than the conventional diffusion item. Magnetism is an unconventional way to improve thermoelectric performance and magnetic metallic systems with high carrier concentration can also be candidates for thermoelectric application. Full‐Heusler alloys (fHAs) exhibit high mechanical strength with earth‐abundant elements, but their metallic properties tend to display small electron diffusion thermopower, limiting potential applications as excellent thermoelectric (TE) materials. Here, it is demonstrated that the Co‐based fHAs Co2XAl (X = Ti, V, Nb) exhibit relatively high thermoelectric performance due to spin and charge coupling. Thermopower contributions from different magnetic mechanisms, including spin fluctuation and magnon drag are extracted. A significant contribution to thermopower from magnetism compared to that from electron diffusion is demonstrated. In Co2TiAl, the contribution to thermopower from spin fluctuation is higher than that from electron diffusion, resulting in an increment of 280 μW m−1 K−2 in the power factor value. Interestingly, the thermopower contribution from magnon drag can reach up to ‐47 μV K−1, which is over 2400% larger than the electron diffusion thermopower. The power factor of Co2TiAl can reach 4000 μW m−1 K−2 which is comparable to that of conventional semiconducting TE materials. Moreover, the corresponding figure of merit zT can reach ≈0.1 at room temperature, which is significantly larger than that of traditional metallic materials. The work shows a promising unconventional way to create and optimize TE materials by introducing magnetism.

High-Performance Thermomagnetic Gd-Si-Ge Alloys

Tunable Magnetocaloric Effect in Ni-Mn-Ga Microwires.

Evaluation of thermomagnetic generation performance of classic magnetocaloric materials for harvesting low-grade waste heat

Thermomagnetic Generation Performance of Gd and La(Fe, Si) 13 H y /In Material for Low‐Grade Waste Heat Recovery

Efficient and affordable thermomagnetic materials for harvesting low grade waste heat

High-performance thermomagnetic generator controlled by a magnetocaloric switch

Structure and Magnetic Study of Ni-Mn-Ga/Al Composite with Modified Magnetocaloric Properties and Enhanced Thermal Conductivity

Enhanced Magnetocaloric Performance in Nanocrystalline/amorphous Gd3Ni/Gd65Ni35 Composite Microwires

Excellent thermomagnetic power generation for harvesting waste heat via a second-order ferromagnetic transition

Microstructure, Magnetism and Critical Behavior of Hot Pressed Ni-Mn-Ga/Al Magnetocaloric Composites with Enhanced Thermal Conductivity and Mechanical Properties

Heat Recovery Assisted by Thermomagnetic-Electric Conversion

Magnetocaloric Effect and Critical Behavior in Melt-Extracted Gd60Co15Al25microwires

Enhancing Energy Efficiency of Thermomagnetic Generators: A Comprehensive Study on Frequency and Heat Dissipation

Advancements in Ge-Based Thermoelectric Materials for Efficient Waste Heat Energy Conversion: A Comprehensive Review

Design, optimization and operation of a high power thermomagnetic harvester

Significant optimization of active thermomagnetic generator for low-grade waste heat recovery

Giant-thermal-expansion Martensitic Alloys for Ultrahigh-Efficiency Solid-State Heat-Pumping

Understanding the High Thermoelectric Performance of Mg3Sb2‐Mg3Bi2 Alloys

Large Improvement of Thermoelectric Performance by Magnetism in Co‐Based Full‐Heusler Alloys

A high performance eco-friendly MgAgSb-based thermoelectric power generation device near phase transition temperatures

Realizing an Excellent Conversion Efficiency of 14.5% in the Mg3Sb2/GeTe-based Thermoelectric Module for Waste Heat Recovery