Abstract:The moving bed biofilm reactor (MBBR) has certain advantages, such as high wastewater treatment efficiency, low maintenance and operating costs, and simple operation. It has emerged as a valuable option for small decentralized facilities. The filling ratio, aeration mode and aeration intensity are the main factors that affect the performance of MBBRs in wastewater treatment. However, the information that concerns the used criteria that pertain to the process design for the MBBR is not adequate. In this study, a three dimensional computational fluid dynamics (CFD) model was constructed and the maximum error was only 1.98%, which was much smaller than the traditional 2D-CFD model. The filling ratio, aeration mode and aeration intensity of MBBR were optimized by CFD model from the point of view of fluid mechanics. The results show that the fluidization performance of the filling is the best under the one-side aeration mode with 30% filling ratio. The cost-performance ratio of the reactor with 30% filling ratio was 1.53, 25% and 35% filling ratio were only 1.17 and 1.14 respectively. Increasing the aeration intensity could improve the fluidization performance. However, the effect of high aeration intensity on the fluidization performance of the carrier was limited and the energy consumption increased greatly. The results revealed that when the aeration intensity increased from 0.07 min-1 to 0.13 min-1, the proportion of the carrier area increased by 16.56%. The proportion of the carrier area with an aeration rate of 0.20 min-1 was only 4.23%, which is higher than 0.13 min-1. The main factors that control the fluidization of the carrier were the range of the flow zone and the flow velocity of the liquid. Increasing the range of the flow zone could facilitate the flow of the carriers. The critical value of the flow velocity of the liquid in the flow zone was 0.04 m/s. These results could guide the optimization design of the filling ratio and the aeration conditions and provide a theoretical basis for the application of MBBR.

Determination of filter bed structure characteristics and influence on performance of a 3D matrix biofilter in gaseous chlorobenzene treatment

Effects of nitrogen source, empty bed residence time and inlet concentration on biofilter removal of chlorobenzene

Experimental study of seepage flow properties with biofilm development in porous media with different filter morphologies

Performance and biofilm characteristics of a gas biofilter for n-hexane removal at various operational conditions

Study on Gaseous Chlorobenzene Treatment by a Bio-Trickling Filter: Degradation Mechanism and Microbial Community

Effects of Adding Inert Spheres into the Filter Bed on the Performance of Biofilters for Gaseous Toluene Removal

Effects of adding ozone on a biofilter treating gaseous chlorobenzene: Performance change and mechanism

Numerical study on filtration characteristics of high-temperature particulate matter in a three-dimensional randomly arranged multi-granularity particle bed filter

Numerical simulation of a multilayer granular bed filter: Effect of bed structure on the filtration characteristics of high-temperature particulate matter

The use of novel packing material for improving methane oxidation in biofilters

Effect of the Empty-bed Residence Time on the Filtering Pool of Biological Activity

Improvement of MBBR Performance by the Addition of 3D-Printed Biocarriers Fabricated with 13X and Bentonite

Advantages of combined UV photodegradation and biofiltration processes to treat gaseous chlorobenzene.

Numerical Simulation of Air Flow Through A Biofilter with Heterogeneous Porous Media

Seawater biofiltration pre-treatment system: comparison of filter media performance

Effects of Design Parameters on Performance and Cost Analysis of Combined Ultraviolet-Biofilter Systems Treating Gaseous Chlorobenzene Based on Mathematical Modeling

Numerical study of hydrodynamic characteristics in a moving bed biofilm reactor

Performance Evaluation of a Methane Biofilter Under Steady State, Transient State and Starvation Conditions

Improvement of MBBR-MBR Performance by the Addition of Commercial and 3D-Printed Biocarriers

Experimental study on filtration characteristics of a novel moving granular bed filter

Biofilm colonization characteristics of tridimensional floating bed in treating micro-polluted river source water