Response spectrum-based analysis of airborne radar random vibration and multi-point control improvement

Jie Liu,Zezheng Liu,Wanqian Chen,Jing Lv,Zixuan Jiang,Jiahao Pang,Libin Du

DOI: https://doi.org/10.1038/s41598-024-56783-y

IF: 4.6

2024-03-31

Scientific Reports

Abstract:During the flight of a UAV (unmanned aerial vehicle), the LiDAR device undergoes random vibrations due to the changing flight attitude and wind speed conditions of the UAV. It is important to control the frequency and amplitude of the vibrations within a reasonable range by means of a damping structure. As the vibrations caused by various factors during flight are random and non-linear, this paper innovates the analysis principle and damping control means for the random vibrations of airborne optoelectronic devices. The response spectrum analysis theory is used to establish the shock response spectrum, and an optimised and improved recursive digital filtering method is used to fit the frequencies of random vibration to the synthetic shock response. Considering the uncertainty of the vibration excitation signal, a virtual excitation method is used for the first time to simulate the random vibration to which the radar may be subjected in the air, and to simplify the calculation steps. The shock plate structure is designed using a multi-point control method to innovate a passive response to the random excitation. Finally, a modal analysis of the synthesised impact response was carried out. It is verified that the first six modal frequencies are controlled within 220 Hz, realising the frequency reduction. The amplitude of the three x, y, and z directions is controlled to within 0.5 mm, thus achieving vibration damping.

multidisciplinary sciences

What problem does this paper attempt to address?

The problem that this paper attempts to solve is the random vibration problem of LiDAR devices carried by unmanned aerial vehicles (UAVs) during flight caused by factors such as attitude changes and wind speed. These random vibrations will lead to changes in the emission direction and position of the laser beam, making the radar data noisy and unstable and affecting the radar performance and detection accuracy. Therefore, how to effectively reduce or suppress the impact of such vibrations on LiDAR performance has become an important research direction.

Specifically, this paper proposes a random vibration modeling and control method based on the response spectrum analysis theory and the multi - point control method, aiming to optimize the anti - vibration performance of LiDAR devices by designing a reasonable vibration - reduction structure. The following are the main innovation points of this paper:

1. **Introduction of virtual excitation method**: In order to simplify the calculation steps and simulate the random vibrations that UAVs may encounter in the air, the virtual excitation method is adopted for the first time to simulate the random vibrations received by the radar.
2. **Optimization of recursive digital filtering method**: An improved recursive digital filtering method is used to fit the random vibration frequency to the synthetic impact response, thereby improving the computational efficiency and accuracy.
3. **Multi - point control strategy**: A multi - point - controlled damping structure is designed to achieve a passive response to random excitation and ensure that the system can accurately control the frequency and amplitude of vibration.
4. **Modal analysis verification**: Through modal analysis of the synthetic impact response, it is verified that the first six - order modal frequencies are controlled within 220 Hz, and the amplitudes in three directions (x, y, z) are controlled within 0.5 mm, achieving an effective vibration - reduction effect.

Through these methods, this paper provides a new vibration - suppression scheme for LiDAR devices carried by UAVs, which helps to improve the detection accuracy and reliability of the radar.