Abstract:All-carbon flexible supercapacitors are highly promising in powering up wearable electronics in smart textiles. However, their low energy density hinders their practical application due to the lack of an effective fabrication method of highly conductive fiber electrodes with high specific capacitance. Herein, we develop a sustainable, scalable, and cost-effective method to fabricate lignin-based carbon/graphene fiber (GF) hybrid electrodes with a hierarchically porous structure. This engineered structure is achieved by coaxially wet spinning a graphene oxide fiber (GOF) as a core structural support and 0–10% lignin/graphene oxide (GO) as a surface layer, followed by carbonization and KOH activation processes. The obtained fiber electrodes exhibit the highest specific capacitance of 260.48 mF cm–2 at a current density of 0.1 mA cm–2, which is 11 times that of the neat GF from conventional wet spinning. The entire-device energy density of the assembled fiber-based flexible supercapacitors from the optimal fiber electrode is 5.79 μW h cm–2 in a H2SO4/poly(vinyl alcohol) electrolyte. Furthermore, the fiber-based flexible supercapacitors show ultralong cycling life and cycling stability (the capacitance retention rate is 98% after 7000 cycles of charge/discharge at a current density of 0.1 mA cm–2). This work enables the high-value utilization of low-cost carbon precursors (lignin and GO) in potential applications such as energy storage devices for smart textiles.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsaem.1c01379.Polarized optical microscopy image of GO solution at 15 mg mL–1; SEM images of the neat GF and unactivated 5% ; FTIR images of the GOF and GF; CV and GCD curves of the GF, unactivated 5% recorded at 5 mV s–1 and 0.1 mA cm–2; CV and GCD curves of flexible supercapacitors tested in a 2-electrode cell in 1 M H2SO4/PVA electrolyte of 0–10% ; electrical conductivity of ; calculated CA, CV, Esingle,A, and Psingle,A values of fiber electrodes based on GCD curves at a current density of 0.1 mA cm–2; calculated CA of fiber electrodes at different scan rates based on CV measurements; and calculated CA of fiber electrodes at current densities based on GCD measurements (PDF)This article has not yet been cited by other publications.

Vaporized Hydrothermal Functionalization of Carbon Fiber and Its Superior Supercapacitor Performance

Boosting Supercapacitive Performance of Flexible Carbon Via Surface Engineering.

Electrochemical and Hydrothermal Activation of Carbon Fiber Supercapacitor Electrode

Facile Activation of Commercial Carbon Felt As a Low-Cost Free-Standing Electrode for Flexible Supercapacitors

Control of Nano Grains and Wide Carbocyclic Layer Space of Forming Active Carbon with Extraordinary Capacitance Characteristics in Supercapacitors

Preparation and Electrochemical Properties of PF-based Activated Carbon

Joule Heating-Induced Carbon Fibers for Flexible Fiber Supercapacitor Electrodes

Simple Mixed-Acid-Treated Carbon Fiber Electrodes with Oxygen-Containing Functional Groups for Flexible Supercapacitors

Biobased Nano Porous Active Carbon Fibers for High-Performance Supercapacitors

A high-performance supercapacitor based on activated carbon fibers with an optimized pore structure and oxygen-containing functional groups

Green H2O2 activation of electrospun polyimide-based carbon nanofibers towards high-performance free-standing electrodes for supercapacitors

Enhanced Surface Area, Graphene Quantum Dots, and Functional Groups for the Simple Acid-Treated Carbon Fiber Electrode of Flexible Fiber-Type Solid-State Supercapacitors without Active Materials

A strategy to prepare activated carbon fiber membranes for flexible solid-state supercapacitor applications

Biomass-Derived Carbon Fiber Aerogel As a Binder-Free Electrode for High-Rate Supercapacitors

Electrochemical Performance of Coaxially Wet-Spun Hierarchically Porous Lignin-Based Carbon/Graphene Fiber Electrodes for Flexible Supercapacitors

Free-standing carbon nanofiber fabrics for high performance flexible supercapacitor

Super-Hydrophilic Coal-Based Carbon Fibers as Flexible Electrodes for Supercapacitors

Surface engineering of reclaimed carbon fiber (RCF) electrode for superimposed supercapacitor performance

Utilization Mild and Green Oxidation Method to Fabricate Skin-Core Structure Derived from Non Melting-Shrinkage PPS Carbon Fibers with Ultra-Thin Nanosheets for High Performance Asymmetric Supercapacitor

Preparation of Advanced Multi-Porous Carbon Nanofibers for High-Performance Capacitive Electrodes in Supercapacitors

Reclaimed Carbon Fiber-Based 2.4 V Aqueous Symmetric Supercapacitors