Abstract:Efficient and feasible removal of trace antibiotics from wastewater is extremely important due to its environmental persistence, bioaccumulation, and toxicity, but still remains a huge challenge. Herein, three natural phenol-inspired porous organic polymers were fabricated from natural phenolic-derived monomers (p-hydroxy benzaldehyde, 2,4-dihydroxy benzaldehyde and 2,4,6-trihydroxy benzaldehyde) and melamine via polycondensation reaction. Characterization highlighted that the increasing contents of hydroxyl groups in monomers induced an increase of the polymer total porosity and promoted the formation of a highly microporous structure. With mesopore-dominated pore (average pore diameter 9.6 nm) and large pore volume (1.78 cm3/g), p-hydroxy benzaldehyde-based porous polymer (1-HBPP) exhibited ultra-high maximum adsorption capacity (qmax) of 697.6 mg/g for tetracycline (TC) antibiotic. Meanwhile, the porous networks and plentiful active sites of 1-HBPP enabled fast adsorption kinetics (within 10 min) for TC removal, which could be well described by the pseudo-second-order model. Dynamic adsorption studies showed that 1-HBPP could be used in fixed-bed adsorption column (FBAC) with high removal efficiency (breakthrough volume per unit mass, 13.2 L/g) and dynamic adsorption capacity (201.6 mg/g), which were much higher than other reported adsorbents. The breakthrough curves both well matched with Thomas and Yoon-Nelson models in FBAC treatment. Moreover, removal mechanism analysis affirmed that pore-filling, hydrogen bonding, electrostatic interactions and π-π stacking interactions were main driving forces for TC adsorption. The prepared natural phenol-inspired porous adsorbents show great potential in antibiotics removal from wastewater, and this strategy would promote the sustainable and high-value utilization of natural phenolic compounds.

The efficient adsorption of tetracycline from aqueous solutions onto polymers with different N-vinylpyrrolidone contents: equilibrium, kinetic and dynamic adsorption

Nitrogen-rich magnetic hyper-cross-linked polymer as an efficient adsorbent for tetracycline

Natural phenol-inspired porous polymers for efficient removal of tetracycline: Experimental and engineering analysis

Utilizing a novel green ternary polymeric nanocomposite material to remove tetracycline antibiotic effectively from aqueous solutions

Synthesis of N,S-containing Hyper-Cross-linked Polymers and Their Efficient Tetracycline and Diclofenac Sodium Adsorption in Water

Surface Hydrophilic Imprinted Particles Via a Green Precipitation Polymerization for Selective Removal of Tetracycline from Aqueous Solution

Efficient Removal of Antibiotics From Water via a Novel Magnetic Hypercrosslinked Polymer

Preparation of hypercrosslinked polymer with benzotriazole and its derivatives as monomers and high-efficiency adsorption of tetracycline

Nitrogen-doped magnetic porous carbon material from low-cost anion-exchange resin as an efficient adsorbent for tetracyclines in water

Construction and characterization of sodium alginate/polyvinyl alcohol double-network hydrogel beads with surfactant-tailored adsorption capabilities for efficient tetracycline hydrochloride removal

Evaluation and optimization of six adsorbents for removal of tetracycline from swine wastewater: Experiments and response surface analysis

Adsorption of tetracycline antibiotics by nitrilotriacetic acid modified magnetic chitosan-based microspheres from aqueous solutions

Polydopamine magnetic microspheres grafted with sulfonic acid groups for efficient adsorption of tetracycline

Effectively removing tetracycline from water by nanoarchitectured carbons derived from CO2: Structure and surface chemistry influence

Efficient removal of tetracycline by reusable magnetic microspheres with a high surface area

Synergic removal of tetracycline using hydrophilic three-dimensional nitrogen-doped porous carbon embedded with copper oxide nanoparticles by coupling adsorption and photocatalytic oxidation processes

Simple Urea Immersion Enhanced Removal Of Tetracycline From Water By Polystyrene Microspheres

Magnetic Porous Material Derived from Ni-MOF for the Removal of Tetracycline from Aqueous Solution

Facile synthesis of nitrogen-doped porous graphene for efficient adsorption of tetracycline: Behavior and mechanism

Induced-fit Adsorption of Diol-Based Porous Organic Polymers for Tetracycline Removal.

Insights into the adsorption mechanism of tetracycline on hierarchically porous carbon and the effect of nanoporous geometry