Abstract:The long‐stroke electromagnetic repulsion mechanism is subjected to large stresses during the driving phase, and the repulsion disc is prone to fracture due to excessive vibration amplitude up and down. Therefore, it is necessary to reduce the peak stress and vibration amplitude of the repulsion disc, improve the mechanical life, and improve the driving performance without decreasing the motion displacement, but it is not possible to do so at present. To address this problem, this paper takes the 'coil‐repulsion disc type' electromagnetic repulsion mechanism as the research object, and builds a simulation model of electromagnetic repulsion mechanism with structural strength and driving performance by using finite element simulation software, and analyzes the effects of four structural parameters, namely, the height of the repulsion disc, the inner diameter of the repulsion disc, the radius of the circular table and the radius of the chamfer, on the displacement and stress distribution of the model. After that, 39 sets of samples were output by BBD experimental design method, which were introduced into the BP neural network prediction model and combined with NSGA‐II algorithm to optimize the structure of the electromagnetic repulsion mechanism. The simulation results show that with the repulsion disc height of 14 mm, the repulsion disc inner diameter of 14 mm, the radius of the circular table is 29.78 mm and the chamfer radius of 7.06 mm, the peak stress of the repulsion disc of the electromagnetic repulsion mechanism is reduced by 57.83%, the amplitude of the repulsion disc is reduced by 3.24 mm, the peak electromagnetic repulsion force is increased by 7.52 kN and speed at the end of 3 ms increased by 9.8%. Under the condition of satisfying the constraints and increasing the overall displacement, the structural strength is increased and the driving performance of the mechanism is ensured to be improved, providing reasonable mechanism parameters for the opening and closing requirements of the fast mechanical switch. © 2023 Institute of Electrical Engineer of Japan and Wiley Periodicals LLC.

Optimized Design for Armature Lightweighting and Contact Pressure Distribution Uniformization Based on BP Neural Network and Genetic Algorithm

Multi-Structural Optimization of Bearingless Permanent Magnet Slice Motor Based on Virtual Prototype in Ansoft Maxwell

Design and Implementation of Lightweight Thigh Structures for Biped Robots Based on Spatial Lattice Structure and Additive Manufacturing Technology.

Optimal Design of Composite Grid/skin Structures Based on Deep Learning and Double-Double Layup Strategy

An Even-Load-distribution Design for Composite Bolted Joints Using a Novel Circuit Model and Neural Network

Optimization for Giant Magnetostrictive Actuator Based on Genetic Algorithm

An even-load-distribution design for composite bolted joints using a novel circuit model and artificial neural networks

Bionic topology optimization design and multi-objective optimization of guide arm

Structure–connection–performance integration lightweight optimisation design of multi-material automotive body skeleton

Optimisation of current collection quality of high-speed pantograph-catenary system using the combination of artificial neural network and genetic algorithm

Structural optimization of thermal stresses in BGA solder joints based on improved BP neural network-genetic algorithm

Structural Optimization Design of Electromagnetic Repulsion Mechanism Based on BP Neural Network and NSGA‐II

Light-Weighting and Comparative Simulation Analysis of the Forearm of Welding Robots

Electromechanical Performance of Rails With Different Cross-Sectional Shapes in Railgun

Multi-objective optimization design for anti-fatigue lightweight of dump truck carriage combined with machine learning

CSAPSO-BPNN-Based Modeling of End Airbag Stiffness of Nursing Transfer Robot

Structure and process optimization and performance analysis of carbon fiber composite industrial robot big arm

Electromagnetic Fields Calculation and Optimization of Structural Parameters for Axial and Radial Helical Air-Core Inductors

Structural Optimization Design of Dual Robot Gripper Unloading Device Based on Intelligent Optimization Algorithms and Generative Design

Optimizing the static–dynamic performance of the body-in-white using a modified non-dominated sorting genetic algorithm coupled with grey relational analysis

Optimization of five-axis tool grinder structure based on BP neural network and genetic algorithm