Abstract:Although blood flows are mostly laminar, transition to turbulence and flow separations are observed at curved vessels, bifurcations, or constrictions. It is known that wall-shear stress plays an important role in the development of atherosclerosis as well as in arteriovenous grafts. In order to help understand the behavior of flow separation and transition to turbulence in post-stenotic blood flows, an experimental study of transitional pulsatile flow with stenosis was carried out using time-resolved particle image velocimetry and a microelectromechanical systems wall-shear stress sensor at the mean Reynolds number of 1750 with the Womersley number of 6.15. At the start of the pulsatile cycle, a strong shear layer develops from the tip of the stenosis, increasing the flow separation region. The flow at the throat of the stenosis is always laminar due to acceleration, which quickly becomes turbulent through a shear-layer instability under a strong adverse pressure gradient. At the same time, a recirculation region appears over the wall opposite to the stenosis, moving downstream in sync with the movement of the reattachment point. These flow behaviors observed in a two-dimensional channel flow are very similar to the results obtained previously in a pipe flow. We also found that the behavior in a pulsating channel flow during the acceleration phase of both 25% and 50% stenosis cases is similar to that of the steady flow, including the location and size of post-stenotic flow separation regions. This is because the peak Reynolds number of the pulsatile flow is similar to that of the steady flow that is investigated. The transition to turbulence is more dominant for the 50% stenosis as compared to the 25% stenosis, as the wavelet spectra show a greater broadening of turbulence energy. With an increase in stenosis to 75%, the accelerating flow is directed toward the opposite wall, creating a wall jet. The shear layer from the stenosis bifurcates as a result of this, one moving with the flow separation region toward the upper wall and the other with the wall jet toward the bottom wall. Low wall-shear stress fluctuations are found at two post-stenotic locations in the channel flow – one immediately downstream of the stenosis over the top wall (stenosis side) inside the flow separation region, and the other in the recirculation region on the bottom wall (opposite side of the stenosis).

Lattice Boltzmann simulation on particle suspensions in a two-dimensional symmetric stenotic artery

Lattice Boltzmann simulation on particle suspensions in a two-dimensional symmetric stenotic artery.

Simulation of Multi-Particle Suspensions in a Quasi-Two-dimensional Symmetric Stenotic Artery with Lattice Boltzmann Method

Numerical simulation of blood flow in stented aneurysm using lattice Boltzmann method

Large-Scale Lattice Boltzmann Method Simulations of Stenosed Carotid Bifurcation.

Simulation of blood flow in arteries with aneurysm: Lattice Boltzmann Approach (LBM)

Lattice Boltzmann model for simulation of flow in intra-cranial aneurysms considering non-Newtonian effects

Viscous Flow Simulation in a Stenosis Model Using Discrete Particle Dynamics: a Comparison Between DPD and CFD.

Lattice Boltzmann Method for Simulating the Viscous Flow in Large Distensible Blood Vessels

Lattice Boltzmann simulation of viscoelastic flow past a confined free rotating cylinder

Simulation of a Pulsatile Non-Newtonian Flow Past a Stenosed 2D Artery with Atherosclerosis

Transitional Pulsatile Flows with Stenosis in a Two-Dimensional Channel

Lattice Boltzmann Study of Non-Newtonian Blood Flow in Mother and Daughter Aneurysm and A Novel Stent Treatment

A nonlinear axisymmetric model with fluid-wall interactions for steady viscous flow in stenotic elastic tubes.

In silico model of stent performance in multi-layered artery using 2-way fluid-structure interaction: influence of boundary conditions and vessel length

Lattice Boltzmann Simulation Of Blood Flow In Cerebral Aneurysm

Multifaceted simulation: Finite volume and finite element modeling of blood flow in multiple stenosed arteries

Experiment-Based Numerical Simulation Of Unsteady Viscous Flow In Stenotic Collapsible Tubes

Eulerian- lagrangian dense discrete phase model (DDPM) of stenotic LAD coronary arteries in comparison with single phase modeling

A two-layered suspension (particle-fluid) model for non-Newtonian fluid flow in a catheterized arterial stenosis with slip condition at the wall of stenosed artery

Lattice Bgk Simulations of the Blood Flow in Elastic Vessels