A Comprehensive Investigation of Linear and Nonlinear Beam Models on Flexible Wind Turbine Blade Load Calculations

Xinwen Ma,Xianghua Peng,Jingwei Sun,Yan Chen,Zhihong Huang
DOI: https://doi.org/10.3390/jmse12040548
IF: 2.744
2024-03-26
Journal of Marine Science and Engineering
Abstract:This study was performed to investigate the effects of structural nonlinearity and large deformations on the aeroelastic loads of flexible wind turbine blades. First, a blade structural analysis model was established using the geometrically exact beam (GEB) theory. Subsequently, the blade element momentum (BEM) theory was corrected using the geometrically exact method leading to the development of a geometrically exact blade element momentum (GE-BEM) model. The results from the GE-BEM model indicated that flapwise deformations always reduce blade fatigue loads, while torsional deformations decrease fatigue loads under low wind speeds but increase them under high wind speeds. Finally, the linear Euler–Bernoulli beam and the GEB were compared to explore the influence of geometric nonlinearity on the blade aeroelastic loads, which revealed that the Euler beam model underestimates the blade loads. The simulations that used the GEB model produced torsional root twist fatigue loads that were 57.49% greater than those generated when the Euler beam model was used. Furthermore, the flapwise bending moment fatigue loads at the root were 8.24% greater than those obtained by the Euler beam model. The smallest discrepancy between the results of the two models was 7.26%, and it corresponded to the edgewise fatigue load.
oceanography,engineering, marine, ocean
What problem does this paper attempt to address?
The problem this paper attempts to address is: studying the impact of structural nonlinearity and large deformations on the aeroelastic loads of flexible wind turbine blades. Specifically, the authors developed a geometrically exact beam (GEB) theory-based blade structural analysis model and modified the blade element momentum (BEM) theory based on geometrically exact methods to develop a geometrically exact blade element momentum (GE-BEM) model. By comparing the linear Euler-Bernoulli beam model and the GEB model, the influence of geometric nonlinearity on the aeroelastic loads of the blades was investigated. The main research contents include: 1. **Establishing the blade structural analysis model**: Using the geometrically exact beam (GEB) theory to establish the blade structural analysis model. 2. **Modifying the BEM model**: Modifying the BEM model through geometrically exact methods to develop the geometrically exact blade element momentum (GE-BEM) model. 3. **Simulation result analysis**: Comparing the aeroelastic loads of the linear Euler-Bernoulli beam model and the GEB model under different wind speed conditions, particularly the changes in fatigue loads. The study found: - Torsional deformation reduces fatigue loads at low wind speeds but increases fatigue loads at high wind speeds. - Simulation results using the GEB model show that, compared to the Euler-Bernoulli beam model, the root torsional fatigue load increased by 57.49%, and the root bending moment fatigue load increased by 8.24%. These results indicate that traditional linear beam models are inadequate in handling large deformations and nonlinear problems, while the GEB model can more accurately describe the aeroelastic behavior of the blades.