Abstract:Efficient wastewater restoration depends on the robustness and capability of the catalyst to promote sophisticated decontamination technologies. In this study, Co3Fe7-CoFe2O4 nanoparticles (NPs) prepared by facile pyrolysis were completely characterized and used to decompose 2,4-dichlorophenol (2,4-DCP). Furthermore, the catalytic performance and relevant mechanisms involved in the activation of peroxymonosulfate (PMS) were also investigated. The optimal conditions were achieved at the catalyst loading of 0.05 g L-1, PMS dosage of 1.26 g L-1, and pH of 7.7 through the response surface methodology by using the Box-Behnken design model. Under optimal conditions, 97.1% efficiency of 2,4-DCP removal was obtained within 30 min. Moreover, the quenching experiments and electron paramagnetic resonance result indicated that sulfate (SO4 center dot-) and hydroxyl (HO center dot) radicals were considered as the dominant reactive oxygen species, which resulted in the effective removal of 2,4-DCP in the Co3Fe7-CoFe2O4/PMS system. Moreover, Co3Fe7-CoFe2O4 showed efficient catalytic performance in continuous five runs and exhibited less metal leaching of 0.052 and 0.036 mg L-1 for Co and Fe species, respectively. Furthermore, no considerable change was observed in the structural characteristics of the fresh and used Co3Fe7-CoFe2O4 catalytic system. The above-mentioned results indicated that the synergistic effects between Co3Fe7 alloy and CoFe2O4 spinel not only significantly improved the activity and long-term durability of the catalyst, but also accelerated the Co3+/Co2+ and Fe3+/Fe2+ redox cycles. Overall, the Co3Fe7-CoFe2O4/PMS system provides a novel advanced oxidation approach to further develop multifunctional transition metal-based nanomaterials responsible for producing surface-bound radicals and enhancing the remediation of refractory pollutants in the environmental application. (C) 2019 Elsevier Ltd. All rights reserved.

Ternary Co ... O v ... Cu sites Trigger Co-utilization of Endogenous Electron Donor-acceptor for Sustainable Removal of Refractory Low-carbon Fatty Amines in Fenton-like System

Interfacial Engineering Regulating Electronic Structure of Homologous S-scheme Co3O4@C-TiO2 Heterojunction for Enhanced Fenton-like Reaction Activity

In-situ Fe–O Co-Doped Carbon Nitride Heterogenous Catalyst for Enhanced Photo-Fenton Oxidation Performance Towards Recalcitrant Organic Pollutants

Fe, Co, N Co-Doped Hollow Carbon Capsules As a Full Ph Range Catalyst for Pollutant Degradation Via a Non-Radical Path in Fenton-like Reaction

Cu-optimized long-range interaction between Co nanoparticles and Co single atoms: Improved Fenton-like reaction activity

Dual sites design of CoFe/Mg MMO catalyst for effectively suppressing dimethylamine re-emission: Degradation products and DFT calculation

Single-atom sites in metal–N 4 configuration for efficient abatement of refractory organic pollutants via Fenton-like reaction

MOFs Derived Carbon Supporting CuCo Nanospheres As Efficient Catalysts of Peroxymonosulfate for Rapid Removal of Organic Pollutant

Tuning local electronic configuration of single atomic Co catalyst via oxide toward boosting Fenton-like activity for pollutant degradation

Atomically Dispersed Co-Mn Dual Sites Anchored in Photoresponsive Carbon Nitride mediated Peroxymonosulfate Activation for Elimination of Petroleum Hydrocarbon in Water

Selective Oxidation of Emerging Contaminants by High-Valent Cobalt(IV)-Oxo Species: Constructing High-Spin Co(III) Sites in Fenton-like System

Construction of dual active sites on diatomic metal (FeCo−N/C-x) catalysts for enhanced Fenton-like catalysis

Synergistic coupling Co 3 Fe 7 alloy and CoFe 2 O 4 spinel for highly efficient removal of 2,4-dichlorophenol by activating peroxymonosulfate.

Anchoring Cobalt Dual-Atom Pairs on Open Hollow-Structured Carbon Via a Facile In-Situ Synthetic Strategy for Enhanced Advanced Oxidation Processes

Overcoming metals redox rate limitations in spinel oxide-driven Fenton-like reactions via synergistic heteroatom doping and carbon anchoring for efficient micropollutant removal

Unsaturated Single Cobalt Sites for Improved Fenton-Like Reaction Towards High-Valent Metal Species

Regulating the Electronic Structure of Cu Single-Atom Catalysts toward Enhanced Electro-Fenton Degradation of Organic Contaminants via 1O2 and •OH

Modulating electronic structure of Fe site by adjacent Cu site through orbital coupling in Cu-Fe 2 O 3 catalyst derived from Fenton sludge quenching

Overcome the trade-off in electro-fenton chemistry for in situ H 2 O 2 generation-activation by tandem CoFe bimetallic single-atom configuration

Enhanced Fenton-like process via interfacial electron donating of pollutants over in situ Cobalt-doped graphitic carbon nitride

Fabrication of bimetallic MOF with 2D nanosheets structure and rich active sites for enhanced removal of organic pollutants by activation of peroxymonosulfate