A kerfless 30 MHz linear ultrasonic array

J. Cannata,J. Williams,K. Shung
DOI: https://doi.org/10.1109/ULTSYM.2005.1602808
2005-09-18
Abstract:In this study a 30 MHz kerfless linear array design was developed and was compared to a 30 MHz piezo-composite array of identical dimensions. A 2-D finite element model (PZFlex) was used to optimize and compare the performance of both arrays. The modeled results suggested that the kerfless array with two matching layers would have a two-way single element sensitivity 7 dB greater than that of the composite array with one acoustic matching layer. However analysis of one-way directivity patterns for single array elements showed a significant reduction in acceptance angle for the kerfless design due to the expected increase in electromechanical crosstalk. The modeled -6 dB acceptance angles were 28o and 50o for the kerfless array element and composite array element, respectively. Based upon these encouraging results kerfless and composite 30 MHz arrays were fabricated and tested. On average the sensitivity of the kerfless array echo response was only 0.8 dB higher than that of the composite array. The average echo center frequency and bandwidth was slightly higher than that of the composite array, whereas the maximum measured crosstalk for the kerfless array was 14 dB larger than that of the composite array. As expected, this crosstalk increase resulted in a reduction of element acceptance angle. The measured -6dB acceptance angle was 22o for the kerfless array and 35o for the composite array. Based upon these results it is expected that kerfless array technology will provide a viable alternate for high frequency linear array designs but should be considered only when an adequate composite is not available.
What problem does this paper attempt to address?