SOL-GEL BIOACTIVE GLASS COATING FOR IMPROVEMENT OF BIOCOMPATIBLE HUMAN BODY IMPLANT

M. M. Atabaki,R. Jafar,J. Idris
Abstract:Stainless steel 316L is widely used for implantation purposes in orthopedic surgery due to its corrosion resistance, mechanical properties and absolutely low cost. In this study, in order to increase the life span of the implantation, coating process is applied on the stainless steel implant to form a thin film barrier. The hydroxyapatite (HA) coating is used to protect the surface of the implant material. Dip Sol-gel method is applied to produce HA coating on stainless steel due to its low cost and easy to produce. This technique provides several advantages in the control of microstructure and the thickness of the coatings. HA is prepared with different amount of chemical additives, P2O5, Na2C03, and KH2PO4, in order to obtain better gel. The protective atmosphere during sintering process accomplished after sol-gel coating produces good uniformity of coating material and significantly a large reduction in the porosity of the coating film. The coated specimens have been characterized by using scanning electron microscopy (SEM), X-ray diffraction analysis (XRD) and Fourier transform infrared spectroscopy (FT-IR). Observations showed that the coating film is uniform at 900 °C of sintering temperature in vacuum atmosphere. In addition, mechanical properties of the films, such as tensile strength and hardness are studied. The highest value of tensile test and hardness is obtained at 900 °C of sintering temperature. The coatings are dense and tightly attached to the underlying substrates, reaching an average strength of 45.9 MPa.
What problem does this paper attempt to address?