Abstract:Oppositely charged polymer-surfactant systems are expected to interact with formation of coacervate complexes near composition of charge-neutrality. Such behaviour is widely used in formulated products ( e.g. household and personal care), where the co-deposition of coacervates and active ingredients on various surfaces is triggered by dilution. A transition towards the use of more sustainable ingredients is currently ongoing as a response to the need of more environmentally conscious choices in production, albeit slowed down by the often more complex and not fully understood bulk and interfacial behaviour of new ingredients. In this work, mixtures of a medium-chain fatty acid (sodium decanoate) and two grades of bio-based cationic modified inulin were studied. The phase behaviour was determined in a wide composition matrix. The formation of coacervate complexes was observed for the mixture with the higher charge density polymer at a surfactant concentration of 1-3 wt%, close to the surfactant critical micellar concentration in pure water. Such behaviour was confirmed by DLS and SAXS data, suggesting surfactant-polymer complexation in a concentrated phase of packed micelles with a micelle-to-micelle distance of ~4.5 nm. In situ ellipsometry and neutron reflectometry experiments were conducted to study the effect on surface deposition when diluting. The ellipsometry showed an adsorbed mass of ~1.3-1.9 mg/m 2 , consistent with the deposition of a coacervate layer, and considerably higher than the neat, adsorbed polymer layer of ~0.3 mg/m 2 . In the case of the neutron reflectometry experiments, dilution was performed before contact with the surface (pre-mixing), and no adsorption of coacervates was observed, but rather the adsorption of a polymer layer (0.49-0.85 mg/m 2 ). The different results obtained with the different techniques highlight the kinetic nature of bulk coacervate formation and deposition, and the competition between these two phenomena. Maximal deposition can be achieved if one can control this time window either by tuning the composition of the system or the experimental set-up, to mimic the conditions of a specific application.

The influence of surface properties on the cooperative behavior of powdered milks

Foaming properties of milk samples collected at various processing stages in a dairy processing factory across two seasons

Understanding the factors affecting the surface chemical composition of dairy powders: a systematic review

Differences in Physicochemical Properties and Proteomics Analysis of Spray- and Freeze-Dried Milk Powders from Bovine, Goat, and Horse Sources

Flowability and wetting behaviour of milk protein ingredients as influenced by powder composition, particle size and microstructure

Impact of formulation on reconstitution and flowability of spray-dried milk powders

Effect of composition on physical properties of food powders

Effect of Surfactant Type on Foaming Properties of Milk

Interfacial properties of milk proteins: A review

Surface adsorption and lubrication properties of plant and dairy proteins: A comparative study

Multiscale approach to the characterization of the interfacial properties of micellar casein and whey protein blends and their effects on recombined dairy creams

pH-induced physiochemical and structural changes of milk proteins mixtures and its effect on foaming behavior

Functionality of bovine milk proteins and other factors in foaming properties of milk: a review

Comparative Study of Powder Carriers Physical and Structural Properties

Towards natural care products: structural and deposition studies of bio-based polymer and surfactant mixtures

Dominant Albumin-Surface Interactions Under Independent Control Of Surface Charge And Wettability

Physicochemical, techno-functional, and fat melting properties of spray-dried camel and bovine milk powders

Modulating Surface Rheology By Electrostatic Protein/Polysaccharide Interactions

Compositional, physical, functional attributes and flow characterization of spray-dried skim milk powder enriched with honey

A novel approach for dynamic in-situ surface characterisation of milk protein concentrate hydration and reconstitution using an environmental scanning electron microscope

Skin layer stratification in drying droplets of dairy colloids