Design of 3-Times Magnetizer and Rotor of Spoke-Type PMSM Considering Post-Assembly Magnetization

H. Seol,T. Jeong,Hyun-Woo Jun,Ju Lee,D. Kang
DOI: https://doi.org/10.1109/TMAG.2017.2707593
IF: 1.848
2017-05-24
IEEE Transactions on Magnetics
Abstract:Unlike the existing bar-type permanent magnets, it is difficult to magnetize the ferrite spoke-type permanent magnet synchronous motor (PMSM), because the permanent magnet is placed deep inside the shaft. In order to magnetize permanent magnet, a high magnetic field intensity is required. However, the high magnetic field intensity may cause demagnetization of surrounding permanent magnets. It has a bad effect on the magnetization of the permanent magnet and the performance of the spoke-type PMSM. In this paper, we proposed magnetizer models for magnetization of spoke-type 10 pole rotor and the inter-pole winding to reduce the demagnetization of surrounding permanent magnets. Finally, the optimally designed model was manufactured and the performance of the magnetizer was verified.
What problem does this paper attempt to address?