Abstract:Electrochemical CO2 reduction enables the conversion of intermittent renewable energy to value-added chemicals and fuel, presenting a promising strategy to relieve CO2 emission and achieve clean energy storage. In this work, we developed nanosized Cu2O catalysts using the hydrothermal method for electrochemical CO2 reduction to alcohols. Cu2O nanoparticles (NPs) of various morphologies that were enclosed with different crystal facets, named as Cu2O-c (cubic structure with (100) facets), Cu2O-o (octahedron structure with (111) facets), Cu2O-t (truncated octahedron structure with both (100) and (111) facets), and Cu2O-u (urchin-like structure with (100), (220), and (222) facets), were prepared by regulating the content of a polyvinyl pyrrolidone (PVP) template. The electrochemical CO2 reduction performance of the different Cu2O NPs was evaluated in the CO2-saturated 0.5 M KHCO3 electrolyte. The as-synthesized Cu2O nanostructures were capable of reducing CO2 to produce alcohols including methanol, ethanol, and isopropanol. The alcohol selectivity of the different Cu2O NPs followed the order of Cu2O-t < Cu2O-u < Cu2O-c < Cu2O-o (with the total Faradaic efficiencies of alcohol products of 10.7, 25.0, 26.2, and 35.4%). The facet-dependent effects were associated with the varied concentrations of oxygen-vacancy defects, different energy barriers of CO2 reduction, and distinct Cu–O bond lengths over the different crystal facets. The desired Cu2O-o catalyst exhibited good reduction activity with the highest partial current density of 0.51 mA/cm2 for alcohols. The Faradaic efficiencies of alcohol products were 4.9% for methanol, 17.9% for ethanol, and 12.6% for isopropanol. The good electrochemical CO2 reduction performance was also associated with the surface reconstruction of Cu2O, which endowed the catalyst with abundant Cu0 and Cu+ sites for promoted CO2 activation and stabilized CO* adsorption for enhanced C–C coupling. This work will provide a new route for enhancing the alcohol selectivity of nanostructured Cu2O catalysts by crystal facet engineering.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsami.1c03850.DFT calculation methods, procedures for catalyst synthesis, experimental setup, HRTEM images and SAED patterns, cyclic voltammetry curves for calculating double-layer capacitors, LSV and CV curves of the catalysts tested in the N2-saturated 0.5 M KHCO3 electrolyte, Tafel plots of the different catalysts, fitting results of the EIS data to the equivalent circuit for the different catalysts, structure of the different facets and side and top views of the facets after CO2 adsorption, CV curves of the different catalysts tested in N2- and CO2-saturated 0.5 M KHCO3 electrolytes, XPS analysis of Cu2O-o before and after testing in the presence of N2 and CO2, and chronoamperometric i–t curves of the Cu2O-o tested under varied applied potentials (PDF)This article has not yet been cited by other publications.

Mesostructure-Specific Configuration of *CO Adsorption for Selective CO2 Electroreduction to C2+ Products

Low-coordinated copper facilitates the *CH 2 CO affinity at enhanced rectifying interface of Cu/Cu 2 O for efficient CO 2 -to-multicarbon alcohols conversion

Enhanced electroreduction of CO<sub>2</sub> to C<sub>2+</sub> products on heterostructured Cu/oxide electrodes

Enhanced electroreduction of CO2 to C2+ products on heterostructured Cu/oxide electrodes

Oxophilicity-Controlled CO 2 Electroreduction to C 2+ Alcohols over Lewis Acid Metal-Doped Cu δ+ Catalysts

Intermediate-regulated Dynamic Restructuring at Ag-Cu Biphasic Interface Enables Selective CO2 Electroreduction to C2+ Fuels

Tailoring Cu-Based Electrocatalysts for Enhanced Electrochemical CO 2 Reduction to Alcohols: Structure-Selectivity Relationship

Evoking C2+ Production from Electrochemical CO2 Reduction by the Steric Confinement Effect of Ordered Porous Cu2O.

Adjusting *CO Adsorption Configuration over Tandem Trimetallic AuAgCu Heterojunction Boosts CO2 Electroreduction to Ethanol Via Asymmetric C-C Coupling

Weak CO binding sites induced by Cu–Ag interfaces promote CO electroreduction to multi-carbon liquid products

Electron‐Deficient Cu Sites on Cu3Ag1 Catalyst Promoting CO2 Electroreduction to Alcohols

Engineering CO Bridge Adsorption in Cu 2 O-TiO 2 Heterojunction Catalyst for Selective Electrochemical CO 2 Reduction to Ethanol

Selective CO2Electroreduction to Ethanol over a Carbon‐Coated CuOxCatalyst

Nature of C-C coupling and strategy of tuning the catalytic activity of Cu-N-C catalysts for electro-reduction of CO 2 to ethanol

Constructing Cu0/Cu+ interfaces on Cu-based MOFs derivatives to promote the adsorption stability of intermediates in the process of CO2 electroreduction to C2 products

Efficient Electrocatalytic CO2 Reduction to C2+ Alcohols at Defect-Site-Rich Cu Surface

Efficient CO2 Electroreduction to Multicarbon Products at Cusio3/Cuo Derived Interfaces In Ordered Pores

Synthesis of Cu 2 O Nanostructures with Tunable Crystal Facets for Electrochemical CO 2 Reduction to Alcohols

Tailoring the Surface and Interface Structures of Copper‐Based Catalysts for Electrochemical Reduction of CO 2 to Ethylene and Ethanol

Steering Electrochemical Carbon Dioxide Reduction to Alcohol Production on Cu Step Sites

Mesoporous Cu2O microspheres for highly efficient C2 chemicals production from CO2 electroreduction