Abstract:The presence of a wide variety of organic pollutants with different physicochemical characteristics has been investigated in wastewater samples from a municipal solid-waste-treatment plant in Castellón, Spain. An advanced analytical strategy was applied—combined used of two powerful and complementary techniques, GC and LC, both hyphenated with tandem mass spectrometry with triple-quadrupole analyzers. The GC–MS–MS method was based on sample extraction using C18 SPE cartridges and enabled the determination of approximately 60 compounds from different chemical families, for example PAHs, octyl/nonylphenols, PCBs, organochlorine compounds, insecticides, herbicides, and PBDEs. Most of the compounds selected are included as priority contaminants in the European Union (EU) Water Directive. The UHPLC–MS–MS method, which provided high chromatographic resolution and sensitivity and short analysis time, used sample extraction with Oasis HLB SPE cartridges and enabled the determination of 37 (more polar) pesticides. The methodology developed was applied to the analysis of 41 water samples (20 untreated raw leachates and 21 treated samples) collected between March 2007 and February 2009. Amounts of the contaminants investigated rarely exceeded 0.5 μg L−1 in the treated (reverse osmosis) water samples analyzed. As expected, in untreated leachates the number of compounds detected and the concentrations found were notably higher than in treated waters. The most commonly detected pollutants were herbicides (simazine, terbuthylazine, terbutryn, terbumeton, terbacil, and diuron), fungicides (thiabendazole and carbendazim), and 4-t-octylphenol. The results obtained proved that use of reverse osmosis for water treatment was efficient and notably reduced the amounts of organic contaminants found in raw leachate samples. In order to investigate the presence of other non-target contaminants, water samples were also analyzed by using GC–TOF MS and LC–QTOF MS. Several organic pollutants that did not form a part of the previous list of target contaminants were identified in the samples, because of the high sensitivity of TOF MS in full-spectrum acquisition mode and the valuable accurate-mass information provided by these instruments. The insecticide diazinon, the fungicide diphenylamide, the UV filter benzophenone, N-butylbenzenesulfonamide (N-BBSA), the insect repellent diethyltoluamide, caffeine, and the pharmaceuticals erythromycin, benzenesulfonanilide, ibuprofen, atenolol, and paracetamol were some of the compounds identified in the water samples analyzed.

Application of terpenoids for the remediation of environmental water polluted with bisphenol A and its analogs using an in silico approach

Extraction of neonicotinoid pesticides from aquatic environmental matrices with sustainable terpenoids and eutectic solvents

Innovative approaches to electrochemical oxidation of Bisphenol B in synthetic and complex water environments

How to apply terpenoid-based deep eutectic solvents for removal of antibiotics and dyes from water: Theoretical prediction, experimental validation and quantum chemical evaluation

Bisphenol A removal from aqueous solutions using novel UV/persulfate/H2O2/Cu system: optimization and modelling with central composite design and response surface methodology

Efficient Visible-Light-Driven Photocatalysis: Simultaneous Degradation of Multiple Pollutants with Bismuth Oxyhalide Solid Solutions

Bisphenols in water: Occurrence, effects, and mitigation strategies

Sustainable pretreatment of blood samples using hydrophobic eutectic solvents to improve the detection of bisphenol A

A Critical Review on Remediation of Bisphenol S (BPS) Contaminated Water: Efficacy and Mechanisms

Development of hybrid processes for the removal of volatile organic compounds, plasticizer, and pharmaceutically active compound using sewage sludge, waste scrap tires, and wood chips as sorbents and microbial immobilization matrices

Feasibility of Phenolic Contaminant Removal from High-Saline Wastewater by Chloride-Mediated Activation of Peroxymonosulfate (PMS) and Peracetic Acid (PAA)

Deep eutectic solvents on extraction of bisphenol A from water matrices: COnductor like Screening MOdel for Real Solvents prediction and experimental validation

Effective removal of personal care product residues from aqueous media using hydrophobic deep eutectic solvents: Experimental and computational approach

Peroxymonosulfate activation by Fe-N-S co-doped tremella-like carbocatalyst for degradation of bisphenol A: Synergistic effect of pyridine N, Fe-N , thiophene S

Solid phase extraction with rotating cigarette filter for determination of bisphenol A in source and drinking water: computational and analytical studies

Comprehensive supramolecular solvent-based sample treatment platform for evaluation of combined exposure to mixtures of bisphenols and derivatives by liquid chromatography-tandem mass spectrometry

Synthesis and application of molecularly imprinted polymers using sol–gel matrix imprinting technology for the efficient solid-phase extraction of BPA from water

Analytical strategy based on the use of liquid chromatography and gas chromatography with triple-quadrupole and time-of-flight MS analyzers for investigating organic contaminants in wastewater

Fulvic acid enhanced peroxymonosulfate activation over Co-Fe binary metals for efficient degradation of emerging bisphenols

Comparative toxicity reduction potential of UV/sodium percarbonate and UV/hydrogen peroxide treatments for bisphenol A in water: An integrated analysis using chemical, computational, biological, and metabolomic approaches

Bacterial bioremediation as a sustainable strategy for the mitigation of Bisphenol-A