Abstract:INTRODUCTION: Recent researches had shown that, in principle, computer-assisted design, computer-assisted manufacture and rapid prototype technologies (CAD/CAM) can be successfully applied to the fabrication of removable partial denture (RPD) alloy frameworks and replace laboratory crafting techniques. The (CAD/CAM) techniques have been widely used for a long time to manufacture dental prostheses. Polyoxymethylene (POM) also known as acetal resin has been used as an alternative tooth- colored denture base and denture clasps material since 1986 and was promoted primarily for superior esthetic. OBJECTIVES: To evaluate clinically the use of Polyoxymethylene partial dentures designed and fabricated by using CAD/CAM technology compared to conventional cobalt chromium partial denture through both the masticatory efficiency and patient satisfaction. MATERIALS AND METHODS: This clinical trial was conducted on twenty mandibular partially edentulous patients (Kennedy class I) who received two types of RPD. Type I was Polyoxymethylene partial denture designed and fabricated by using CAD/CAM Technology and Type II was cobalt chromium partial denture fabricated using the conventional technique .At time of denture insertion, the masticatory efficiency of both types of dentures was evaluated for each patient .After 3 months of denture use, each patient was clinically evaluated through both the masticatory efficiency and patient satisfaction. RESULTS: Type I RPD showed better masticatory efficiency than Type II RPD but without statistical significant values at different follow up periods. Patients showed more satisfaction with type I RPD than with type II RPD with a significant value. CONCLUSIONS: Polyoxymethylene partial denture designed and fabricated by using CAD/CAM Technology is a favorable treatment for partially edentulous patients showing improvement of masticatory efficiency and favorable patient satisfaction.

CAD-CAM for removable partial denture fabrication after marginal mandibulectomy based on a well-adjusted pre-existing denture

[Application of Computer Aided Design-Computer Aided Manufacture Technique in Mandible Defect Reconstruction with Individual Titanium Prosthesis].

Fabrication of an Immediate Complete Denture with Digital Workflow: A Case Report

Combination of CAD/CAM technologies and conventional processing in the fabrication of a maxillary obturator prosthesis: a clinical report

A digital workflow for designing and manufacturing metal frameworks and removable partial dentures: A novel dental technique

Advances in Computer Aided Design and Computer Aided Manufacturing of Removable Partial Denture

Complete denture digital workflow: Combining basic principles with a CAD-CAM approach

A preliminary study on the design of removable partial denture framework using CAD method

Expediting the Rehabilitation of Severely Resorbed Ridges Using a Combination of CAD-CAM and Analog Techniques: A Case Report

Computer Aided Design and Computer Aided Manufacture of Sacrificial Pattern of Removable Partial Denture Framework

Design of Complete Dentures by Adopting CAD Developed for Fixed Prostheses

A Preliminary Report of Designing Removable Partial Denture Frameworks Using A Specifically Developed Software Package

Preliminary Study on CAD of Removable Partial Denture Framework

Advantages of CAD/CAM versus Conventional Complete Dentures - A Review

Preliminary Clinical Application of Removable Partial Denture Frameworks Fabricated Using Computer-Aided Design and Rapid Prototyping Techniques.

[Design of Geometric Models of the Removable Partial Denture Framework].

A Novel Computer-Aided Design/Computer-Assisted Manufacture Method for One-Piece Removable Partial Denture and Evaluation of Fit.

Treatment of edentulous and partially edentulous patients with CAD/CAM frameworks: a pilot case study

Digital Duplication and 3D Printing for Implant Overdenture Fabrication

CLINICAL EVALUATION OF POLYOXYMETHYLENE PARTIAL DENTURES DESIGNED AND FABRICATED BY USING CAD/CAM TECHNOLOGY

Facially Driven Digital Workflow for Maxillary and Mandibular Milled Implant- Retained Overdentures Using Two Different Unsplinted Attachment Systems: Case Report