Abstract:The relationship between solution properties, film-forming methods, and the solid surface structures of random copolymers composed of butyl methacrylate and dodecafluorheptyl methylacrylate (DFHMA) was investigated by contact angle measurements, X-ray photoelectron spectroscopy, sum frequency generation vibrational spectroscopy, and surface tension measurements. The results, based on thermodynamic considerations, demonstrated that the random copolymer chain conformation at the solution/air interface greatly affected the surface structure of the resulting film, thereby determining the Surface segregation of fluorinated moieties on films obtained by various film-forming techniques. When the fluorinated monomer content of the copolymer solution was low, entropic forces dominated the interfacial structure, with the perfluoroalkyl groups unable to migrate to the solution/air interface and thus becoming buried in a random-coil chain conformation. When employing this copolymer solution for film preparation by spin-coating, the copolymer chains in solution were likely extended due to centrifugal forces, thereby weakening the entropy effect of the polymer chains. Consequently, this resulted in the segregation of the fluorinated moieties on the film surface. For the films prepared by casting, the perfluoroalkyl groups were, similar to those in solution, incapable of segregating at the film surface and were thus buried in the random-coil chains. When the copolymers contained a high content of DFHMA, the migration of perfluoroalkyl groups at the solution/air interface was controlled by enthalpic forces, and the perfluoroalkyl groups segregated at the surface of the film regardless of the film-forming technique. The aim of the present work was to obtain an enhanced understanding of the formation mechanism of the chemical structure on the surface of the polymer film, while demonstrating that film-forming methods may be used in practice to promote the segregation of fluorinated moieties on film surfaces.

EFFECT OF CHANGES IN SULFUR COMPOUNDS ON STABILITY AND GELATION OF CASEINS AND OF STERILE CONCENTRATED MILK.

Surface segregation of fluorinated moieties on random copolymer films controlled by random-coil conformation of polymer chains in solution.

Malignant Potential of Cervical Dysplasia: Diagnosis and Treatment

Effect of Solvents on Surface Segregation Behavior of Fluorinated Block Copolymer Films

Novel Non-Fluorinated Surfactants for Emulsion Polymerization of Fluorinated Monomers

Surface Heterogeneity of A Fluorinated Block Copolymer Melt Studied by A Self-Consistent-Field Analysis

Preparation and fluorine enrichment behavior of fluorinated polyester

Measurement and Modeling of End Group Concentration Depth Profiles for ω-Fluorosilane Polystyrene and Its Blends

The Effect of Poly(ethylene glycol) (PEG) Length on the Wettability and Surface Chemistry of PEG-Fluoroalkyl-Modified Polystyrene Diblock Copolymers and Their Two-Layer Films with Elastomer Matrix

Aza‐Michael Addition Chemistry for Tuning the Phase Separation of PDMS/PEG Blend Coatings and Their Anti‐Fouling Potentials

Sustainable Design of Non-Fluorinated yet Oleophobic Fibrous Surfaces

Surface Segregation in Polymer Blends and Interpolymer Complexes with Increasing Hydrogen Bonding Interactions

On the surface hydrophilization of a blended polysulfone membrane: atomic force microscopy measurement and molecular dynamics simulation

CONTACT ANGLE AND SURFACE TENSION STUDY OF THE BLENDS OF PS-b-PMTFPS AND POLYSTYRENE

Towards understanding the behavior of polyelectrolyte surfactant mixtures at the water vapor interface closer to technologically relevant conditions

Evolution of Concentration Fluctuation During Phase Separation of Polystyrene/Poly(Vinyl Methyl Ether) Blend in the Presence of Nanosilica

Facile fabrication of patterned polymeric films via phase separation-induced surface segregation

Surface Composition of Biopolymer Blends Biospan-SP/Phenoxy and Biospan-F/Phenoxy Observed with SFG, XPS, and Contact Angle Goniometry

Interrogation of a fluoropolymer dispersion manufactured with a non-fluorinated polymerization aid for targeted and non-targeted fluorinated residuals by liquid chromatography high resolution mass spectrometry

Temperature‐dependent Phase‐segregation Behavior and Antifouling Performance of UV‐curable Methacrylated PDMS/PEG Coatings

Mesoscale Polymer Surfactants: Photolithographic Production and Localization at Droplet Interfaces