Abstract:Fouling control strategies play a crucial role in membrane distillation (MD) process, primarily due to the significant limitation of fouling during the scaling-up process. The utilization of microbubbles (MBs) aeration has exhibited promising potential in mitigating membrane fouling when treating high salinity wastewater. Aeration can introduce gas-liquid two-phase flow on the membrane surface, thereby increasing the membrane surface shear force. The mechanism of aeration technology for controlling fouling includes the following points: introduction of gas-liquid two-phase flow; physical substitution of concentration polarization layer; pressure pulses caused by bubbles flowing through the membrane surface and increasement of the cross flow velocity. This research aims to optimizing the effect of air MBs with different concentrations and sizes introduced in the feed side on membrane fouling control, we creatively used the method of releasing pressure gradiently to achieve size regulation of MBs within a certain range for the first time, firstly regulated the generation of MBs by manipulating gas flow rate and release pressure. Under the optimal condition of 40 mL/min and 0.6 MPa, it will yield concentration of 1.58 × 10 4 /mL and D50 Sauter size of 64.69 μm MBs with pure water permeance flux of 12.32 kg/(m 2 ·h). It was observed that higher gas flow rates primarily increased MBs concentration, while lower pressures predominantly reduced MBs size through the method of inline imaging. Experimental results indicated that introduction of MBs can slightly improve the temperature polarization coefficient and mass transfer coefficient under different operating modes. Consequently, further investigations focused on the influence of MBs characteristics on different fouling control. All conditions reach 99 % rejection for inorganic salt and HA. This study provided empirical evidence that higher concentration and larger size of MBs intensify the gas-liquid two-phase flow disruption and exhibit a better shear effect on scaling phenomena, which yield advantageous outcomes in terms of augmenting permeance flux and water vapor production, with permeance flux increased from 40.12 % to 55.42 % for inorganic fouling and increased from 68.35 % to 80.15 % for inorganic and HA fouling. These results were confirmed via membrane surface using scanning electron microscopy and energy dispersive spectroscopy. In summary, this research aided in identifying appropriate operating conditions for mitigating inorganic and composite scaling by implementing air-infused MBs in direct contact membrane distillation (DCMD), which provides scientific and technical guidance for controlling fouling in MD in practical applications.

Improving membrane distillation performance by Fe(II) activated sodium percarbonate oxidation during the treatment of shale gas produced water

Water quality of shale gas produced water greatly influences the performance of membrane distillation

Fertilizer-driven FO and MD integrated process for shale gas produced water treatment: Draw solution evaluation and PAC enhancement

Gravity-driven membrane integrated with membrane distillation for efficient shale gas produced water treatment

Enhanced Mitigation of Membrane Fouling and Degradation of Perfluorooctanoic Acid in the Treatment of Natural Surface Water Through the Application of Dielectric Barrier Discharge/sulfite

Performances and mechanisms of the peroxymonosulfate/ferrate(VI) oxidation process in real shale gas flowback water treatment

Enhancing microfiltration membrane performance by sodium percarbonate-based oxidation for hydraulic fracturing wastewater treatment

Improved Ultrafiltration Performance Through Dielectric Barrier Discharge/sulfite Pretreatment: Effects of Water Matrices and Mechanistic Insights

Membrane Distillation Hybrid Peroxydisulfate Activation toward Mitigating the Membrane Wetting by Sodium Dodecyl Sulfate

Application of Sodium Percarbonate Activated with Fe(II) for Mitigating Ultrafiltration Membrane Fouling by Natural Organic Matter in Drinking Water Treatment

Synergistic Mechanism of Combined Ferrate and Ultrafiltration Process for Shale Gas Wastewater Treatment

Janus C-PAN/PH membrane for simulated shale gas wastewater (SGW) treatment in membrane distillation: Integrating surface property and catalytic degradation for anti-fouling

Treatment of coal gasification brine by membrane distillation: Effect of mixed fouling and pretreatment on process performance

Understanding the membrane fouling control process at molecular level in the heated persulfate activation- membrane distillation hybrid system

Electrochemically activated peroxymonosulfate (PMS) pretreatment for fouling remediation during membrane distillation of surface water: Role of PMS concentration and dosing mode

Ferrate(VI)-based oxidation for ultrafiltration membrane fouling mitigation in shale gas produced water pretreatment: Role of high-valent iron intermediates and hydroxyl radicals

Surface functionalization of polytetrafluoroethylene membrane by polydopamine and quaternary ammonium compound for fouling mitigation in membrane distillation of secondary effluent

Photothermally-activated Peroxymonosulfate (PMS) Pretreatment for Fouling Alleviation of Membrane Distillation of Surface Water: Performance and Mechanism

Distribution and transformation of dissolved organic matters (DOMs) in membrane distillation for desulfurization wastewater in thermal power plant

Effects of Fe(Ii)-Activated Persulfate/Sodium Percarbonate (ps/spc) Pretreatment on Ultrafiltration Membrane Fouling Control and Mechanisms

Optimizing fouling mitigation in membrane distillation by controlled microbubble size and concentration