Effect of Cd on Structural, Spectral, Morphological and Dielectric Properties of Sr1-xCdxZn2Fe4O11 R-type Hexaferrites Synthesized via Sol-gel Technique

Ambreen Aleem,Hasan M Khan,Muhammad Zahid,Chun Ouyang,Muhammad Iqbal Hajana,Waqar Azeem,Maria Atriq,Imed Boukhris,Imen Kebaili

DOI: https://doi.org/10.1016/j.heliyon.2024.e33271

IF: 3.776

2024-06-28

Heliyon

Abstract:Sol-gel method was used to prepare Sr1-xCdxZn2Fe4O11 (x = 0.00, 0.02, 0.06, 0.1) R-type hexaferrite. The synthesized materials were sintered at 850oC and desired phase was obtained. X-ray diffraction analysis confirms that R-type hexaferrite exists only as a single phase. Using the Scherer formula, crystallite size for all of the prepared samples was found to be in the range of 10.39-12.62 nm. Crystallite size (D), the lattice parameters (a, c), and the cell volume (Vcell), d-spacing, bulk density, X-ray density, porosity, dislocation density and micro strain were determined in structural analysis. Fourier transform infrared spectroscopy method was used to identify the metal-oxygen vibrations at different locations. FT-IR verifies the presence of the Fe-O stretching vibration band at 743 and 867 cm-1. The typical grain size in surface morphology investigation ranges from 0.56 to 0.82 μm. Dielectric response of ferrite ceramic samples replaced with Cd2+ was investigated in the frequency range of 1 MHz-3 GHz. The AC conductivity rises with an increase in frequency because they are proportional to one another. This increasing tendency is effectively described by the theory of Maxwell-Wagner and Koop. Q-values remain constant as frequency rises and behaves independently of frequency as long as frequency reaches 1.7 GHz. These types of materials are utilized in high-frequency applications including frequency filters and resonant circuits. All of the magnetic properties determined by analyzing the M - H loops, including saturation magnetization (Ms), retentivity (Mr), and coercivity (Hc), exhibit an increasing trend as the substitution of Cd2+ rises. Ms (49.76-56.38 emu/g), Mr (15.82-18.30 emu/g) and Hc range from 203.20 Oe to 215.80 Oe. Grain size decreases cause arise in coercivity, which is caused by an enhancement in magneto-crystalline anisotropy. Overall results suggest that Cd2+ replaced R-type hexagonal ferrites are a great resource for longitudinal recording media; they have the potential to be used in a wide variety of electronic applications, including resonant circuits and high-frequency filters, security, detecting and switching.