Abstract:The Euler–Lagrange method is a great way for multiphase bubble flow simulation, the detailed information of bubbles can be effortlessly obtained, and it is helpful for the efficiency and safety of different industry processes. Traditionally, the computational fluid dynamics-discrete bubble model (CFD-DBM) method has always been used to simulate this flow process. Nevertheless, the ability of the traditional CFD-DBM method is significantly limited in terms of the size ratio between the grid and bubble, where the grid size must be larger than the bubble size. In reality, the bubble may be larger than the grid and the grid/bubble size ratio can be very large due to the effects of complex bubble dynamics (such as the bubble breakup and coalescence) and complex internal flows. To address this issue, an improved CFD-DBM method is proposed in this study, which can be used for the simulation with a wide grid/bubble size ratio in gas–liquid–bubble multiphase simulation, and the volume of fluid (VOF) method is applied to capture the interface between gas and liquid phases. A gradient-based interpolation method is employed to reconstruct the liquid velocity around the target bubble when the grid size is much larger than the bubble size. If the bubble size is comparable with or larger than the grid size, the interphase force correction and the field smoothing will be carried out within a spherical support area. Subsequently, the proposed model is validated by the comparison with a bubble column experiment, in terms of the bubble size distribution and bubble vertical velocity. The results demonstrate the high accuracy of the new method. Finally, the influence of different parameters including normal spring stiffness, critical Weber number, and the range of the spherical support area on the bubble flow is investigated.

Experimental and numerical simulation research on the transport process of bubble clusters in aeration system

Experiment and Numerical Simulation of the Motion of Bubble Swarm in a Bubble Column

Experimental and Numerical Investigations of Scale-Up Effects on the Hydrodynamics of Slurry Bubble Columns

Experimental Investigation of Flow Development in Large-Scale Bubble Columns in the Churn-Turbulent Regime

Experimental Measurement and Theoretical Analysis on Bubble Dynamic Behaviors in a Gas-Liquid Bubble Column

Bubble Size “bimodal” Distribution Enhances Mixing and Mass Transfer in Slurry Bubbling Column Reactor

Numerical Simulations Of Fluid Dynamics And Mixing In A Large Shallow Bubble Column: Effects Of The Sparging Pipe Allocations For Multiple-Pipe Gas Distributors

Study on the Numerical Model of Gas-Liquid Dispersion Driven by a Coaxial Mixer

Computational study on microscale behavior of bubble generated by aeration in a plug-flow aeration tank.

Experimental and numerical investigations of motion and mass transfer of single bubbles in a turbulent flow chamber

Numerical Simulation of Aeration Bubble Growth in A Plug-Flow Aeration Tank Used in Wastewater Treatment

Direct numerical simulation of deformable rising bubbles at low Reynolds numbers

Numerical Simulation of Mass Transfer Characteristics of Gas–Liquid Bubble Columns and an Improved Mass Transfer Model

An Improved Computational Fluid Dynamics-Discrete Bubble Model for Multiphase Bubble Flow Simulation with a Wide Grid/bubble Size Ratio

Numerical Simulation Of Bubbly Flow Using Partially Averaged Navier-Stokes Simulation And A Path Oscillation Model In The Euler-Lagrange Approach

Numerical simulation on vortex flow and CO2 bubble aggregation behavior in a raceway pond with diaphragm aerators

Tow-dimensional CFD simulation of bubbly flow in structured packings

Numerical simulations of bubbly flows in a vertical periodic channel

Study on Coupling Effect and Dynamic Behavior of Double Bubbles Rising Process

Mechanisms and Modeling of Bubble Dynamic Behaviors and Mass Transfer under Gravity: A Review

Numerical simulation of single bubble motion fragmentation mechanism in Venturi-type bubble generator