Abstract:To address the challenges posed by solid waste generated from coal gasification ash, a pyrolysis self-activation method was employed to prepare activated carbon by gasification ash, followed by the modification with manganese oxide to enhance its adsorption performance. Subsequently, the removal efficiency and mechanism for copper citrate were investigated. The results demonstrated the successful preparation of manganese oxides modified gasification ash-derived activated carbon (GAC-MnOx), exhibiting a specific surface area of 158.3 m2/g and a pore volume of 0.1948 cm³/g. The kinetic process could be described by the pseudo-second-order kinetic model (R2 = 0.958). High removal efficiency and low concentration of dissolved Mn were observed within the pH range of 3-10, where the adsorption capacity of GAC-MnOx for copper citrate exhibited an inverse relationship with pH. Notably, the fitting results of the Langmuir model demonstrated that the maximum adsorption capacity of GAC-MnOx for copper citrate is determined to be 7.196 mg/g at pH 3. The adsorption capacity of GAC-MnOx was found to be significantly reduced to 0.26 mg/g as the pH decreased below 2, potentially attributed to the dissolution of Mn. The findings of the Dual-Mode model demonstrated that the copper citrate removal mechanism by GAC-MnOx involved both surface adsorption and precipitation processes as follows: the porous structure of activated carbon enables physical adsorption of copper citrate, the MnOx or oxygen-containing functional groups establish chemical bonds with copper citrate and subsequently precipitate onto the surface of the adsorbent. The physical adsorption remains predominant in the removal of copper citrate, despite a gradual decrease in its proportion with increasing pH and equilibrium concentrations. Moreover, the X-ray photoelectron spectroscopy results indicated that copper citrate might be oxidized by MnOx to release copper ions and be retained on the surface of the adsorbent, meaning the adsorption efficiency of Cu(II)-Cit by GAC was enhanced through MnOx oxidation. This study could provide a new strategy for the high-value resource utilization of gasification ash.

Coupled physicochemical dual-crosslinking Ti3C2Tx composite aerogels for the selective adsorption of gallium ions in acid fly ash leaching

Preparation of graphene-based surface ion-imprinted adsorbent for Ga(III) selective extraction from acid leaching of fly ash

Alginate-based adsorbents with adjustable slit-shaped pore structure for selective removal of copper ions

A green synthesis method of a mussel-inspired polyphenol-functionalized silica-based material and its highly efficient adsorption of gallium

Facile fabrication of tannic acid functionalized microcrystalline cellulose for selective recovery of Ga(III) and In(III) from potential leaching solution

One-step green synthesis of melamine-modified cellulose nanofiber composite aerogels for efficient removal of Pb(II) and Cu(II): Experiments and DFT calculations

Highly selective capture of gallium from aqueous solutions using tetradentate amidoxime functionalized MIL-53(Al) nanofiber membranes

Selective adsorption of Cu(II) on amino-modified alginate-based aerogel: As a catalyst for the degradation of organic contaminant

Graphene Oxide Covalently Functionalized with 5-Methyl-1,3,4-thiadiazol-2-amine for pH-Sensitive Ga3+ Recovery in Aqueous Solutions

Porous carboxymethyl cellulose nanocrystalline imprinted composite aerogels for selective adsorption of gadolinium

Graphene oxide/montmorillonite composite aerogel with slit-shaped pores: Selective removal of Cu2+ from wastewater

Preparation of three-dimensional 2-mercaptothiazoline modified GO aerogel for selective adsorption of Cu 2+ in aqueous solution

Graphene oxide/polydopamine modified montmorillonite/carboxymethyl chitosan composite aerogel for efficient removal of Pb 2+ , Cu 2+ , and Cd 2+ : Adsorption behavior, mechanism and DFT study

Green composite aerogel based on citrus peel/chitosan/bentonite for sustainable removal Cu(II) from water matrices

Enhanced adsorption and separation of gallium using silica-based P507-TBP/SiO2–P adsorbent from sulfuric acid solution

A novel mussel-inspired layered montmorillonite-based composite aerogel for high-efficiency removal of heavy metal ions

MMT and ZrO 2 jointly regulate the pore size of graphene oxide-based composite aerogel materials to improve the selective removal ability of Cu(II)

Enhanced Gallium Extraction Using Silane-Modified Mesoporous Silica Synthesized from Coal Gasification Slag

A new strategy for utilization of gasification ash: Manganese oxides-modified activated carbon for efficient copper citrate removal

Extraction of Valuable Metals and Preparation of Mesoporous Materials from Circulating Fluidized Bed-Derived Fly Ash via an Acid–Alkali-Based Alternate Method

3D magnetic MXene as promising adsorbent materials for Ag(I) removal