Effect of irradiation modification on conformation and gelation properties of pork myofibrillar and sarcoplasmic protein
Chengliang Li,Lichao He,Sumin Ma,Wenmin Wu,Haiyan Yang,Xiuxiu Sun,An Peng,Lujie Wang,Guofeng Jin,Jianhao Zhang,Yongguo Jin,Meihu Ma
DOI: https://doi.org/10.1016/j.foodhyd.2018.05.047
IF: 10.7
2018-01-01
Food Hydrocolloids
Abstract:As a promising non-thermal decontamination technique, γ-irradiation has been practically used to ensure microbial safety of meat and meat products, but its effects on the properties of meat have not yet been fully understood. So, this study mainly investigated the effects of different doses irradiation (0, 3, 5 and 7 kGy) on the muscle protein conformation, surface hydrophobicity, solubility, particle size, turbidity and thermal stability. The results of CD spectroscopy showed that 3 kGy disrupted the beta-sheet to form unordered structures in SP while increasing dose level recovered the ordered structures in SP, especially the increased alpha-helix content of SP after 7 kGy irradiation. In case of MP, beta-turn exhibited a dose-dependent reduction and 7 kGy irradiation resulted in a dramatic increase in beta-sheet compared with MP control (P < 0.05). The DSC and SDS-PAGE results indicated that 3 kGy irradiation could promote the actomyosin formation in MP, but ≥5 kGy irradiation favored its depolymerization. And after irradiation, the solubility and particle size of SP was reduced significantly (P < 0.05). Consequently, turbidity of SP and MP reached their maximum value at 5 kGy and 3 kGy irradiation, respectively. Upon irradiation, WHC of both SP and MP gels dropped significantly (P < 0.05) with increasing dose level. Rheological analysis demonstrated that, during thermal gelation, the G′ and G″ of SP decreased as irradiation dose increased due to greater protein denaturation. Microrheological behavior and Turbiscan results showed that irradiated SP samples exhibited significantly higher TSI compared with SP control, but ≥5 kGy irradiation exhibited a stronger EI and MVI value in MP, indicating the enhanced inter-droplet resistance force inside MP.