Abstract:Wire and arc additive manufacturing (WAAM) has emerged as a highly promising technique for manufacturing large-scale steel structural elements. However, the distinct mechanical properties of WAAM steel could potentially lead to different performance of WAAM steel bolted connections compared to the traditional steel bolted connections. This study aims to investigate the material properties of WAAM steel and the structural behaviours of WAAM steel bolted connections, focusing on the effects of print layer orientation and connection plate geometrical dimensions. A total number of 24 WAAM steel coupon specimens with three different print layer orientations and 36 WAAM double-shear bolted connections with two print layer orientations and different geometric dimensions were designed, fabricated and tested under monotonic tension. These specimens were measured using a 3D laser scanner and Digital Image Correlation (DIC) was adopted to measure the structural response during testing. The impact of print layer orientations on WAAM material properties and the effects of WAAM material properties on bolted connections were analysed and discussed. The current design codes for traditional steel bolted connections were evaluated against the test results of WAAM steel bolted connections. The study found that the print layer orientations of WAAM steel plates initiated an anisotropic material property of the coupon specimens, demonstrated by the differences in ultimate tensile strength and strain of specimens with different print layer orientations. Five failure modes, including net section tension, shear-out, bearing, end-splitting, and block shear failure were observed for the bolted connections. The material anisotropy further affects the performance of the bolted connections, though in the same dimensions, 28% of the specimens presented different failure modes due to the different print layer orientations. The effectiveness of current steel design standards was compromised by inaccurate predictions of failure modes due to the distinct end-splitting failure mode and the effects of material anisotropy, though the predictions of the ultimate capacities of the WAAM lap shear specimens were relatively accurate.

Corrosion Performance of Wire Arc Additive Manufacturing of Stainless Steel: A Brief Critical Assessment

Mechanical Properties, Microstructural Characteristics and Heat Treatment Effects of WAAM Stainless-Steel Plate Material

Improving mechanical strength and isotropy for wire-arc additive manufactured 304L stainless steels via controlling arc heat input

Experimental Study on Wire and Arc Additively Manufactured Steel Double-Shear Bolted Connections

Microstructure and Mechanical Properties of 304L Steel Fabricated by Arc Additive Manufacturing

Corrosion response of steels fabricated through arc directed energy deposition additive manufacturing: A review

Wire Arc Additive Manufacturing: A Comprehensive Review and Research Directions

Electrochemical insight into the passivity and corrosion of 316 L stainless steel fabricated through wire arc additive manufacturing

The Corrosion Behavior of 316L Stainless Steel Additively Manufactured by Direct Energy Deposition Process

A Brief Review on The Common Defects in Wire Arc Additive Manufacturing

A critical review of wire arc additive manufacturing of nickel-based alloys: principles, process parameters, microstructure, mechanical properties, heat treatment effects, and defects

Review of post-processing methods for high-quality wire arc additive manufacturing

Environmental Behavior of Low Carbon Steel Produced by a Wire Arc Additive Manufacturing Process

Mechanical, metallurgical, and corrosion investigations on wire arc additively manufactured low carbon steel

Effect of Phase Transformation on Stress Corrosion Behavior of Additively Manufactured Austenitic Stainless Steel Produced by Directed Energy Deposition

Microstructure and Corrosion Properties of Stainless Steel 308L Prepared by Cold Metal Transfer–Wire Arc Additive Manufacturing

A Review of the Recent Developments and Challenges in Wire Arc Additive Manufacturing (WAAM) Process

Microstructural Evolution, Mechanical and Electrochemical Performance of Duplex Stainless Steel Fabricated by Wire Arc Additive Manufacturing with ER2209 Filler Wire

A Review of High-Strength Aluminum-Copper Alloys Fabricated by Wire Arc Additive Manufacturing: Microstructure, Properties, Defects, and Post-processing

A review of wire arc additive manufacturing and advances in wire arc additive manufacturing of aluminium

An Extensive Review On Wire Arc Additive Manufacturing