Effects of structural parameters on water film properties of transpiring wall reactor

Donghai Xu,Peng Feng,Yang Wang,Wanpeng Yang,Yu Wang,Shaoyan Sun
DOI: https://doi.org/10.1002/aic.17472
IF: 4.167
2021-10-10
AIChE Journal
Abstract:Corrosion and salt deposition problems severely restrict the industrialization of supercritical water oxidation. Transpiring wall reactor can effectively weaken these two problems by a protective water film. In this work, methanol was selected as organic matter, and the influences of vital structural parameters on water film properties and organic matter removal were studied via numerical simulation. The results indicate that higher than 99% of methanol conversion could be obtained and hardly affected by transpiration water layer, transpiring wall porosity and inner diameter. Increasing layer and porosity reduced reactor center temperature, but inner diameter's influence was lower relatively. Water film temperature reduced but coverage rate raised as layer, porosity and inner diameter increased. Notably, the whole reactor was in supercritical state and coverage rate was only approximately 85% in the case of one layer. Increasing reactor length affected slightly the volume of the upper supercritical zone but enlarged the subcritical zone.This article is protected by copyright. All rights reserved.
engineering, chemical
What problem does this paper attempt to address?