Abstract:Short of a vaccine, frequent and rapid testing, preferably at home, is the most effective strategy to contain the COVID-19 pandemic. Herein, we report on single-stage and two-stage molecular diagnostic tests that can be carried out with simple or no instrumentation. Our single-stage amplification is reverse transcription-loop mediated isothermal amplification (RT-LAMP) with custom-designed primers targeting the ORF1ab and the N gene regions of the virus genome. Our new two-stage amplification, dubbed Penn-RAMP, comprises recombinase isothermal amplification (RT-RPA) as its first stage and LAMP as its second stage. We compared various sample preparation strategies aimed at deactivating the virus while preserving its RNA and tested contrived and patient samples, consisting of nasopharyngeal swabs, oropharyngeal swabs, and saliva. Amplicons were detected either in real time with fluorescent intercalating dye or after amplification with the intercalating colorimetric dye LCV, which is insensitive to sample's PH. Our single RT-LAMP tests can be carried out instrumentation-free. To enable concurrent testing of multiple samples, we developed an inexpensive heat block that supports both the single-stage and two-stage amplification. Our RT-LAMP and Penn-RAMP assays have, respectively, analytical sensitivities of 50 and 5 virions/reaction. Both our single- and two-stage assays have successfully detected SARS-CoV-2 in patients with viral loads corresponding to the reverse transcription-quantitative polymerase chain reaction (RT-qPCR) threshold cycle smaller than 32 while operating with minimally processed samples, without nucleic acid isolation. Penn-RAMP provides a 10-fold better sensitivity than RT-LAMP and does not need thermal cycling like PCR assays. All reagents are amenable to dry, refrigeration-free storage. The SARS-CoV-2 test described herein is suitable for screening at home, at the point of need, and in resource-poor settings.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acs.analchem.1c03016.Experimental details of qRT-PCR, calibration curve establishment, verification of the specificity of the LAMP Assay, investigation of infectivity of coronavirus and RNA integrity after heat treatment, blocker heater fabrication; results and discussion on the comparison of Direct RT-LAMP with OptiGene Reaction Mix and NEB Colorimetric Master Mix; and additional experimental data (PDF)This article has not yet been cited by other publications.

Development of a reverse transcription loop-mediated isothermal amplification assay with novel quantitative pH biosensor readout method for SARS-CoV-2 detection

A Novel Reverse Transcription Loop-Mediated Isothermal Amplification Method for Rapid Detection of SARS-CoV-2

Development and Validation of a Highly Sensitive RT-qLAMP Assay for Rapid Detection of SARS-CoV-2: Methodological Aspects

Lateral flow–based nucleic acid detection of SARS-CoV-2 using enzymatic incorporation of biotin-labeled dUTP for POCT use

Ultrasensitive and fast detection of SARS-CoV-2 using RT-LAMP without pH-dependent dye

Development and Validation of a Rapid, Single-Step Reverse Transcriptase Loop-Mediated Isothermal Amplification (RT-LAMP) System Potentially to Be Used for Reliable and High-Throughput Screening of COVID-19

Developing RT-LAMP assays for rapid diagnosis of SARS-CoV-2 in saliva

Rapid and Accurate Detection of Three Genes in SARS-CoV-2 Using RT-LAMP Method

Development of Reverse Transcription Loop-mediated Isothermal Amplification (RT-LAMP) Assays Targeting SARS-CoV-2

Development of a reverse transcription recombinase polymerase amplification assay for rapid and direct visual detection of Severe Acute Respiratory Syndrome Coronavirus 2 (SARS-CoV-2)

Rapid and Visual Detection of 2019 Novel Coronavirus (Sars-Cov-2) by a Reverse Transcription Loop-Mediated Isothermal Amplification Assay

Single- and Two-Stage, Closed-Tube, Point-of-Care, Molecular Detection of SARS-CoV-2

Portable and Label-Free Quantitative Loop-Mediated Isothermal Amplification (LF-qLamp) for Reliable COVID-19 Diagnostics in Three Minutes of Reaction Time: Arduino-Based Detection System Assisted by a pH Microelectrode

Isothermal Amplification and Ambient Visualization in a Single Tube for the Detection of SARS-CoV-2 Using Loop-Mediated Amplification and CRISPR Technology

Phenol red as electrochemical indicator for highly sensitive quantification of SARS-CoV-2 by loop-mediated isothermal amplification detection

An alternative colorimetric RT-LAMP assay for the rapid detection of SARS-CoV-2: development and validation in Thailand

Optimization of Reverse Transcription Loop-Mediated Isothermal Amplification for In Situ Detection of SARS-CoV-2 in a Micro-Air-Filtration Device Format

Clinical validation of optimised RT-LAMP for the diagnosis of SARS-CoV-2 infection

Development of an Electrochemical Sensor for SARS-CoV-2 Detection Based on Loop-Mediated Isothermal Amplification

A colorimetric reverse transcription-loop mediated isothermal amplification (RT-LAMP) method for the rapid detection of SARS-CoV-2 in Thailand

Rapid and Visual Detection of SARS-CoV-2 Using Multiplex Reverse Transcription Loop-Mediated Isothermal Amplification Linked With Gold Nanoparticle-Based Lateral Flow Biosensor