POLYPEPTIDE CHAINS OF HUMAN FIBRIN: MOLECULAR ORGANIZATION IN CROSS‐LINKING *

R. Mcdonagh,J. Mcdonagh,B. Blombäck

DOI: https://doi.org/10.1111/j.1749-6632.1972.tb16346.x

IF: 6.499

1972-12-01

Annals of the New York Academy of Sciences

Abstract:The formation of fibrin is a multiphasic process involving two principal enzymes. Thrombin, by a process of limited proteolysis, removes two peptides from the N-terminal portion of the fibrinogen molecule. A nonenzymatic polymerization follows, resulting in a conversion of the soluble protein, fibrinogen, into an insoluble gel, fibrin. Fibrin may exist in a variety of molecular populations depending on the degree of intraand intermolecular cross-linking catalyzed by Factor XI11 (fibrin-stabilizing factor, FSF). Factor XI11 is found in plasma and platelets as an inactive proenzyme which requires the action of thrombin for activation. Once activated, the enzyme catalyzes the formation of isopeptide bonds between the e-amino groups of certain lysine residues and y-carboxyamide groups of certain glutamines rendering fibrin more elastic and less amenable to resolution by fibrinolytic agents.' Recent interest has focused on the identification of the peptide chains of fibrin which are involved in crosslinking and on the localization of the regions containing cross-linking sites within the chains.3-" Cross-linked and noncross-linked fibrins were prepared, and the component chains were obtained by reduction and alkylation.5 Fibrinogen, fraction 1-4, was clotted with thrombin in the presence of calcium and purified plasma Factor XI11 at pH 7.3 at 37" C for periods up to 24 hours. Control, noncross-linked, fibrin was clotted without Factor XI11 in the mixture and with an equivalent amount of EDTA added in place of calcium. Following incubation, the fibrin was triturated and washed thoroughly with distilled water and then dialyzed extensively against distilled water. After freeze-drying, the fibrin was suspended in 8 M guanidine-Tris buffer, pH 8.5, to a concentration of 2 % , and reduced with a 5 M sulfhydryl excess of dithiothreitol. When reduction was complete, monoiodoacetic acid was added and alkylation was allowed to proceed for 15 minutes, whereupon the reaction was stopped with glacial acetic acid and desalting was carried out on Sephadex G-25. The molecular weights of the fibrin components were estimated by polyacrylamide electrophoresis at neutral pH in sodium dodecyl sulfate (SDS) . 7 Three major components of both cross-linked and noncross-linked fibrins were identified (FIGURE 1 ) . Noncross-linked fibrin was seen to be composed of 7, j3 and a-chains. The molecular weights of these chains were found to be 47,000, 54,000, and 61,000 respectively. The three components of reduced,