A self-powered multi-functional sensor based on triboelectric nanogenerator for monitoring states of rotating motion

Senpeng Lin,Lifeng Zhu,Ye Qiu,Zhengyang Jiang,Yifei Wang,Jun Zhu,Huaping Wu
DOI: https://doi.org/10.1016/j.nanoen.2021.105857
IF: 17.6
2021-05-01
Nano Energy
Abstract:<p>The promptly growing technique of powerless devices based on triboelectric nanogenerator (TENG) offers an opportunity to get rid of external power sources. Especially, plenty of self-powered rotating sensors are proposed but short of the capability to simultaneously detect multi-rotating parameters. A self-powered states of rotating motion sensor (SRM-Sensor) is developed for synchronously monitoring rotating displacement, speed, acceleration. It is mainly constructed by rack-shaped plates and incomplete gears. Symmetrical setup of incomplete gears design amplifies triboelectric output signal twofold and the sensitivity is 580 mV/rpm. After connecting to rectified bridge and filter capacitor circuit, the output voltage shows an intuitionistic relationship with rotating speed. The calculated integral and derivation of output voltage curve perfectly fit the rotating displacement and acceleration. The proposed SRM- Sensor potentially paves the way for a rotating motion sensing system with self-powered characteristics to the fields of industrial revolve detecting.</p>
materials science, multidisciplinary,chemistry, physical,physics, applied,nanoscience & nanotechnology
What problem does this paper attempt to address?
This paper aims to address the limitations of self-powered rotational sensors based on triboelectric nanogenerators (TENG) in practical applications, particularly the inability of these sensors to simultaneously detect multiple rotational parameters. Specifically, existing self-powered rotational sensors can monitor rotational speed but perform inadequately in simultaneously monitoring rotational displacement and acceleration. Therefore, this paper proposes a novel self-powered rotational motion state sensor (SRM-Sensor) that can synchronously monitor rotational displacement, speed, and acceleration. ### Main Issues 1. **Limitations of Existing Sensors**: - Existing self-powered rotational sensors mainly rely on current amplitude to read rotational speed, but the current amplitude is too small to be applied in industrial machinery. - The method of converting voltage from the time domain to the frequency domain can establish a relationship between rotational speed and frequency, but it is difficult to directly obtain angular displacement and acceleration, requiring additional software processing, leading to a lack of intuitive correspondence. 2. **Solution**: - A self-powered rotational motion state sensor (SRM-Sensor) based on triboelectric nanogenerators (TENG) is proposed. - By designing a symmetrical incomplete gear structure, two rack-shaped plates slide at the same speed but in opposite directions, thereby doubling the relative speed and significantly increasing the output voltage. - Using a rectifier bridge and filter capacitor circuit, an intuitive relationship between output voltage and rotational speed is established without the need for complex algorithm processing. - The voltage sensitivity of the sensor reaches 580 mV/rpm, with strong resistance to environmental noise. ### Experimental Verification - The performance of the SRM-Sensor at different rotational speeds, including output voltage, current signal, and frequency response, was experimentally verified. - The response time of the sensor in the high-frequency region is about 0.5 seconds, suitable for practical applications such as wind speed or water flow detection. - The use of a rectifier bridge and filter capacitor further improves the stability and noise resistance of the sensor. ### Conclusion - The proposed SRM-Sensor can not only synchronously monitor rotational displacement, speed, and acceleration but also has high sensitivity and good noise resistance. - The design and performance of the sensor demonstrate its great potential in the field of industrial rotational equipment monitoring, especially in real-time monitoring and complex environments. In summary, this paper successfully addresses the shortcomings of existing self-powered rotational sensors in multi-parameter monitoring through innovative design and experimental verification, providing a new solution for practical engineering applications.