Abstract:The adhesion forces between two silica surfaces were measured by using an atomic force microscope with different experimental parameters in air to investigate the dynamic behavior of a confined liquid. Results show that the adhesion force is time-dependent and increases at first sharply and then slightly with dwell time until saturation is reached, with a long equilibrium time. This behavior is well explained by a dynamic meniscus model, in which a liquid bridge grows gradually because of liquid film flow with a large viscosity. Also, the large viscosity was attributed to the formation of orthosilicic acid and subsequent polymerization. With repeated contacts, the liquid bridge changes into two droplets on both surfaces after separation. The liquid in both forms can be controlled to flow into or out of the contact zone by the experimental parameters to achieve tailored adhesion forces. If the liquid of previous contact remains in the contact zone, the adhesion force increases with repeated contacts and then reaches saturation, which can also be explained by the model qualitatively. However, if the liquid droplets vanish before the next contact, the adhesion force usually decreases or remains unchanged. More liquid will be collected with larger contact times. Meanwhile, the droplets remaining on the surfaces get smaller until they vanish without a contact. Moreover, both piezo velocity and scan distance can be used to control the proportion of contact time. In addition, a viscous force should be considered with a large retraction velocity. The changing trend and magnitude of adhesion force depend on the experimental parameters and their coupling effects. The results may facilitate the anti-adhesion design of small-scale silicon-based systems.

Controlling Macroscopic Friction through Interfacial Siloxane Bonding

Contribution of Capillary Adhesion to Friction at Macroscopic Solid–Solid Interfaces

Linking macroscale frictional properties to nanoscale water capillary bridges

Experimental insights into adhesion and friction between nominally dry rough surfaces

Nano-sized single-asperity friction behavior: Insight from molecular dynamics simulations

Quantification/mechanism of Interfacial Interaction Modulated by Electric Potential in Aqueous Salt Solution

Atomic simulations of effects of contact size and interfacial interaction strength on superlubricity in incommensurate sliding interface

Nonmonotonic load‐dependence of friction during nanoparticle manipulation

Nonmonotonic Friction due to Water Capillary Adhesion and Hydrogen Bonding at Multiasperity Interfaces

Time-Dependent Dynamic Behaviors of a Confined Liquid to Achieve Tailored Adhesion Force with Repeated Contacts Revealed by Atomic Force Microscopy

Mechanism of Friction Enhancement Induced by Nanoscale Liquid Film: A Brief Review

Micromechanics of Friction: Effects of Nanometre-Scale Roughness

Low friction under ultrahigh contact pressure enabled by self-assembled fluorinated azobenzene layers

Macroscopic Superlubricity Achieved by Polyacrylic Acid Modified Fe3o4 Nanoparticles As Additives

Nanofriction Mechanisms Derived from the Dependence of Friction on Load and Sliding Velocity from Air to UHV on Hydrophilic Silicon

A Computational Chemistry Approach for Investigation of Low Friction Mechanisms Based on FEP Film with Functionalized SiO2 Nanoparticles

Role of Trapped Molecules at Sliding Contacts in Lattice-Resolved Friction

Microscale Superlubricity at Multiple Gold–graphite Heterointerfaces under Ambient Conditions

Charge-induced ultralow friction between graphite and atomically flat surfaces

Macroscale Superlubricity Enabled by Rationally Designed MoS2-based Superlattice Films

Chemifriction and Superlubricity: Friends or Foes?