Abstract:Background: Tuberculosis (TB) remains a burden to Sri Lanka, where the incidence of the disease has been increasing over the past decade. The lack of early and accurate detection of the disease has been the main obstacle to its control. Microscopy or the culturing of mycobacteria from clinical samples is the most commonly used TB diagnostic tools in Sri Lanka. All these methods have their own limitations. Alternative diagnostic methods are therefore of high importance. Objectives: In this study, an attempt was made to validate loop mediated isothermal amplification (LAMP), which specifically amplifies a DNA sequence very rapidly at a low cost with limited resources. Methods: Crude DNA extractions of fifty culture isolates prepared from sputum samples, which were collected from patients with suspected TB extracts, were subjected to three separate LAMP assays. One assay was specific for 16S ribosomal RNA (16S rRNA) gene in genus Mycobacterium, and could detect the bacteria up to the genus level. The other two contained MTB specific primers targeting rimM or gyrB gene sequences in Mycobacterium tuberculosis (MTB), which enabled detection up to the species level. The sensitivity and specificity of the LAMP assays in the identification of mycobacteria or MTB were compared to microscopy and culture techniques. Results: Forty three out of the 47 Mycobacterium cultures were Mycobacterium-positive for LAMP assays with universal primers indicating a sensitivity of 92% in identifying Mycobacterium genus. However, thirteen out of 14 culture negatives were also positive with LAMP assays, which showed a specificity of only 7% in identifying MTB. The results suggested a high percentage of false positives by LAMP assays as compared to culture. Based on the colour changing of ZYBR Green dye and gel electrophoresis of the LAMP-amplified product, the detection of a non-specific amplification, even in the absence of target DNA, was recurrently observed. The result was the same even after following strict safety operations and laboratory practices to avoid the possibility of a cross-over contamination of MTB. Interestingly, this nonspecific DNA amplicon did not respond to digestion with BsaI restriction enzyme, suggesting that the false positives are not due to the presence of MTB. Conclusion: Under the tested conditions, the specificity of the LAMP method to identify MTB is low as compared to culture technique. Further investigations into optimizing the LAMP assay technique are required before it can be used, in its simple form, to diagnose TB in local clinical settings.

Performance of IS6110-LAMP assay for detection of Mycobacterium tuberculosis complex in blood and urine samples from patients with extrapulmonary tuberculosis

Real-time PCR and Amplified MTD® for Rapid Detection of Mycobacterium Tuberculosis in Pulmonary Specimens.

Diagnostic Accuracy Of The Loop-Mediated Isothermal Amplification Assay For Extrapulmonary Tuberculosis: A Meta-Analysis

Assessment of laboratory performance of Loop-Mediated Isothermal Amplification(LAMP)for detection of Mycobacterium tuberculosis

Diagnostic Performance of Different Laboratory Methods for the Detection of Extrapulmonary Tuberculosis

Evaluation of Digital PCR Assay in Detection of M.tuberculosis IS6110 and IS1081 in Tuberculosis Patients Plasma.

Diagnosis of abdominal tuberculosis by multi‐targeted (mpt64 and IS6110) loop‐mediated isothermal amplification assay

Laboratory validation of a simplified DNA extraction protocol followed by a portable qPCR detection of M. tuberculosis DNA suitable for point of care settings.

Diagnostic accuracy of loop-mediated isothermal amplification for pulmonary tuberculosis in China

The Application of Is6110-Baced Loop-Mediated Isothermal Amplification (lamp) in the Early Diagnosis of Tuberculous Meningitis

Development and evaluation of a multiplex loop-mediated isothermal amplification (LAMP) assay for differentiation of Mycobacterium tuberculosis and non-tuberculosis mycobacterium in clinical samples

Clinical application of loop-mediated isothermal amplification method in rapid detection of Mycobacterium tuberculosis

177-182 Wenjuan Wu-Mycobacterium

Evaluation of real-time loop-mediated isothermal amplification (RealAmp) for rapid detection of Mycobacterium tuberculosis from sputum samples

Ultrafast, One-Step, Label-Based Biosensor Diagnosis Platform for the Detection of Mycobacterium tuberculosis in Clinical Applications

The performance of Xpert MTB/RIF and MTBDRplus within a Programmatic setting at TB Laboratory in Rio de Janeiro, Brazil

Non Specific Amplification with the LAMP Technique in the Diagnosis of Tuberculosis in Sri Lankan Settings

Value of loop-mediated isothermal amplification in detection of Mycobacterium tuberculosis in tuberculous pleural effusion

Value of Mycobacterium Tuberculosis Direct Assay in Early Diagnosis Ofextrapulmonary Tuberculosis.

Establishment and evaluation of a new fluorescent probe method based on loop‐mediated isothermal amplification for the detection of Mycobacterium tuberculosis complex