Abstract:As a result of increased concern over Greenhouse Gas emissions, capture of CO2 from stationary power sources is a topic under discussion throughout the world. The most developed technology for the application is post combustion carbon capture using liquid solvents. However, due to very low concentration of CO2 in the gas turbine emitted flue gas, energy penalty caused by the capture process is relatively high. One of the methods to increase CO2 concentration is the recycling of flue gas (also termed as EGR) in which part of the flue gas is sent back to join the air stream entering the compressor. This paper presents results of an experimental campaign carried out at the Pilot Scale Advanced Capture Technology (PACT) facilities of the UK Carbon Capture and Storage Research Centre (UKCCSRC). A Turbec T100 microturbine of 100kWe is integrated with a post combustion carbon capture plant of 1TPD (Ton per day) CO2 capture capacity. The microturbine is very lean combustion system and produces a flue gas having only 1.5% CO2. Therefore, in order to simulate EGR on industrial gas turbines which produce around 4–5% CO2 in the exhaust stream, CO2 from a cryogenic storage tank was injected into the slip stream of the gas turbine exhaust. The impact of different CO2 concentrations (representing EGR) on the post combustion carbon capture process is experimentally evaluated. It is observed that the energy penalty caused by the capture process is considerably reduced at higher CO2 concentration in the absorber inlet flue gas stream. EGR also has a negative impact on the produced power from the gas turbine as well as the combustion process. However, it has positive impact on the power output from steam turbine. Optimum recycle ratio for maximum power output from combined cycle gas turbine is discussed. Performance of the absorption column as indicated by rich and lean solvent CO2 loadings is discussed. Moreover, emissions of solvent and some of the degradation products with the exhaust gas from the capture plant are monitored and reported.

Carbon capture from biomass flue gases for CO2 enrichment in greenhouses

A Direct Air Capture Rotary Adsorber for CO2 Enrichment in Greenhouses

Post-combustion CO2 capture from a natural gas combined cycle power plant using activated carbon adsorption

Carbon Dioxide Enrichment by Composting in Greenhouses and Its Effect on Vegetable Production

Effect Test of Biomass Carbon Dioxide Fertilizer Application

Indoor CO2 direct air capture and utilization: Key strategies towards carbon neutrality

Enriching and controlling the CO 2 concentration level in indoor farming through electroactive 13X-filled biocarbon tubular elements

CO 2 Fertilization System Integrated with a Low-cost Direct Air Capture Technology

Application of CO_2 enrichment by agricultural wastes composting in greenhouses and its environmental benefits

Environmental and energetic analysis of coupling a biogas combined cycle power plant with carbon capture, organic Rankine cycles and CO2 utilization processes

Integrated Direct Air Capture and CO 2 Utilization of Gas Fertilizer Based on Moisture Swing Adsorption

Reduction of Greenhouse Gas Emissions by Integration of Cement Plants, Power Plants, and CO2 Capture Systems

CO2 enrichment in greenhouse production: Towards a sustainable approach

Integrated direct air capture and CO2 utilization of gas fertilizer based on moisture swing adsorption

Flue-to-fuel: Bio-integrated carbon capture and utilization of dilute carbon dioxide gas streams to renewable methane

CO 2 Capture from Flue Gas on a Pilot Scale Using Porous Carbon Prepared from Cotton Stalk Crop Residues through an Industrially Viable Activation Process

Eco-friendly strategy for CO2 enrichment performance in commercial greenhouses based on the CO2 spatial distribution and photosynthesis

Production of Sustainable Adsorbents for CO2 Capture Applications from Food Biowastes

Co 2 enrichment in ambient air by temperature swing adsorption and its applications for stimulating plant growth in greenhouses

Influence of Gas Turbine Exhaust CO2 Concentration on the Performance of Post Combustion Carbon Capture Plant

Development of a hybrid photo-bioreactor and nanoparticle adsorbent system for the removal of CO2, and selected organic and metal co-pollutants