Abstract:In previous reports, we described a PCR cycle control approach in which the hybridization state of optically labeled L-DNA enantiomers of the D-DNA primers and targets determined when the thermal cycle was switched from cooling to heating and heating to cooling. A consequence of this approach is that it also "adapts" the cycling conditions to compensate for factors that affect the hybridization kinetics of primers and targets. It assumes, however, that the hybridization state of the labeled L-DNA analogs accurately reflects the hybridization state of the D-DNA primers and targets. In this report, the Van't Hoff equation is applied to determine the L-DNA concentration and ratio of L-DNA strands required by this assumption. Simultaneous fluorescence and temperature measurements were taken during L-DNA controlled cycling, and the optical and thermal switch points compared as a function of both total L-DNA concentration and ratio of strands. Based on the Van't Hoff relationship and these experimental results, L-DNA best mirrors the hybridization of PCR primers and targets when total L-DNA concentration is set equal to the initial concentration of the D-DNA primer of interest. In terms of strand ratios, L-DNA hybridization behavior most closely matches the behavior of their D-DNA counterparts throughout the reaction when one of the L-DNA strands is far in excess of the other. The L-DNA control algorithm was then applied to the practical case of the SARS-CoV-2 N2 reaction, which has been shown to fail or have a delayed Cq when PCR was performed without nucleic acid extraction. PCR Cq values for simulated "unextracted" PCR samples in a nasopharyngeal background and in an NaCl concentration similar to that of viral transport media were determined using either the L-DNA control algorithm (N=6) or preset cycling conditions (N=3) and compared to water background controls run in parallel. For preset cycling conditions, the presence of nasopharyngeal background or a high salt background concentration significantly increased Cq, but the L-DNA control algorithm had no significant delay. This suggests that a carefully designed L-DNA-based control algorithm "adapts" the cycling conditions to compensate for hybridization errors of the PCR D-DNA reactants that produce false negatives.

Experiments in Digital Content

Design of signal preamplifier circuit for fluorescence detection system in quantitative PCR instrument.

Simulation and experimental study of temprature lag time for Polymerase Chain Reaction instrument

Comprehensive algorithm for quantitative real-time polymerase chain reaction

Self-correction of cycle threshold values by a normal distribution–based process to improve accuracy of quantification in real-time digital PCR

Removal of between-run variation in a multi-plate qPCR experiment

Absolute quantification of real-time PCR data with stage signal difference analysis

Precise determination of reaction conditions for accurate quantification in digital PCR by real-time fluorescence monitoring within microwells

Utilization of Digital PCR in Quantity Verification of Plasmid Standards Used in Quantitative PCR

A Bayesian method for calculating real-time quantitative PCR calibration curves using absolute plasmid DNA standards

A PCR Primer Bank for Quantitative Gene Expression Analysis.

Statistical significance of quantitative PCR

Optimization of on-bead emulsion polymerase chain reaction based on single particle analysis

Pre-amplification in the context of high-throughput qPCR gene expression experiment

Implementing L-DNA analogs as mirrors of PCR reactant hybridization state: Theoretical and practical guidelines for PCR cycle control

Effect of Taq Enzyme on PCR Quantitative Detect

An improvement of the 2ˆ(-delta delta CT) method for quantitative real-time polymerase chain reaction data analysis.

A two stage model for quantitative PCR

High Fidelity PCR with an Off/on Switch Mediated by Proofreading Polymerases Combining with Phosphorothioate-Modified Primer.

Exploring the Impact of Primer–Template Mismatches on PCR Performance of DNA Polymerases Varying in Proofreading Activity

Accurate quantification of DNA using on-site PCR (osPCR) by characterizing DNA amplification at single-molecule resolution