Abstract:Raman spectroscopy is used in many fields with advantages of no sample pretreatment and simultaneous multiple species detection, while the disadvantage of low sensitivity limits its further a pplication. In order to improve the sensitivity of Raman gas detection, a method for enhancing the gas Raman signal based on a folded near-concentric cavity is reported in this paper. By inserting a high reflectivity plane mirror into the center of multiple reflectors, the cavity body is folded from the center, so that the beams in the center of the cavity overlap with each other to increase the light density and luminous flux, thereby improving the detection sensitivity of the system. Ray tracing and flux analysis are performed on the different cavity modes using TracePro software(laser: 300 mW (R) 532 nm, reflectance: 99% (R) 532 nm). The results show that the optical cavity folding method can significantly increase the optical flux at the center of the reflecting cavity. When the number of reflections in the folded near concentric cavity is 68 times, the luminous flux at the center of the waist is 22. 35 W, which is about 1. 5 times enhancement compared with the unfolded near-concentric reflecting cavity. In order to verify the simulation results, a gas detection Raman spectroscopy system with folded near-concentric cavity is set up. The experimental results show that the folded near-concentric cavity has the best enhancement, reaching 49 times; next is near concentric cavity about 36 times; the third is folding the concentric cavity, a pproximately 24 times; the last is the concentric cavity, just 17 times. The signal-to-noise ratio of the gas Raman signal collected by the folded near-concentric cavity is 1. 4 times higher than that of the unfolded near-concentric cavity. According to the relative intensity of the carbon dioxide Raman peak in the air, we can calculate the limit of detection for CO2 using 3-sigma criterion standard with the value of 0. 13 mg.L-1 (66 ppm).

Cavity-enhanced Raman spectroscopy for simultaneous detection of multiple gases using Pound-Drever-Hall technology

High-Sensitivity and In Situ Multi-Component Detection of Gases Based on Multiple-Reflection-Cavity-Enhanced Raman Spectroscopy

Near-confocal Cavity-Enhanced Raman Spectroscopy for Multitrace-Gas Detection

Multiple Gas Detection Using V-cavity Coupled Diode Laser

Multiple Gas Detection by Cavity-Enhanced Raman Spectroscopy with Sub-ppm Sensitivity

Cavity-enhanced Raman Spectroscopy for Simultaneous Detection of Characteristic Dissolved Gases in Oil

Cavity-enhanced Raman Spectroscopy with Optical Feedback Frequency-Locking for Gas Sensing

Multiple Gases Detection Based on Periodical Mode-Locked Cavity-Enhanced Absorption Spectroscopy Using a Single-Mode Diode Laser

Hazardous Gas Detection by Cavity-Enhanced Raman Spectroscopy for Environmental Safety Monitoring

Quasi-Simultaneous Sensitive Detection of Two Gas Species by Cavity-Ringdown Spectroscopy with Two Lasers

Gas detection using cavity-enhanced Raman spectroscopy with a bidirectional multi-pass cell and polarization beam-splitting optical path

Cavity Enhanced Multi-Channels Gases Raman Spectrometer

Raman Spectroscopy For Gas Detection Using A Folded Near-Concentric Cavity

A Versatile Multiple-Pass Raman System for Industrial Trace Gas Detection

High-Sensitivity Raman Gas Probe for In Situ Multi-Component Gas Detection

[Raman Signal Enhancement for Gas Detection Using a Near Concentric Cavity].

Repetitively Mode-Locked Cavity-Enhanced Absorption Spectroscopy (RML-CEAS) for Near-Infrared Gas Sensing

Sensitive Raman-Scattering-based multi-gas analysis using a narrow line-width violet external cavity diode laser

High-Sensitivity Gas Detection with Air-Lasing-Assisted Coherent Raman Spectroscopy

Development of a Frequency-locking V-shaped Cavity Enhanced Raman Spectrometer for Simultaneous Analysis of Fault Gases

Dense-pattern Multi-Pass Cavity Based on Spherical Mirrors in a Z-shaped Configuration for Raman Gas Sensing