Abstract:Process intensification efforts have renewed interest in the potential of end‐to‐end continuous manufacture with column‐free capture alternatives. This article describes a decisional tool that encompasses mass balance and design equations, process economics, stochastic simulation and multi‐criteria decision‐making and enables the evaluation of different batch, and continuous flowsheets for monoclonal antibody (mAb) manufacture. The traditional batch process was compared with end‐to‐end continuous bioprocesses with either protein A capture or column‐free capture employing aqueous two‐phase extraction or precipitation from economic, environmental, and robustness perspectives. The cost of goods analysis predicted that continuous flowsheets could offer substantial cost savings (~20%–40%) over the batch process at low and medium annual commercial demands (100–500 kg); however, at tonnage demands they resulted in either comparable or higher costs. Comparing the continuous options, the continuous flowsheets with protein A or precipitation yielded similar COG/g values, while aqueous two‐phase extraction presented higher costs. The analysis of overall process mass intensities accounting for water and consumables suggested that the continuous flowsheet with protein A would result in the lowest environmental burden. When the economic, environmental, and operational criteria were reconciled using multi‐criteria decision‐making analysis, the continuous protein A‐based flowsheet was found to be the most favorable. A target analysis highlighted the need for process improvements in the following parameters to reduce the manufacturing costs of the continuous column‐free capture options below that of protein A: the perfusion volumetric productivity, the harvested cell culture fluid percentage in column‐free operations, the column‐free step yields along with the implementation of buffer concentrates.

Model-based process development and evaluation of twin-column continuous capture processes with Protein A affinity resin

Model-based Process Development of Continuous Chromatography for Antibody Capture: A Case Study with Twin-Column System

Process design and application of twin-column continuous chromatography for antibody affinity separation

Antibody Capture with Twin-Column Continuous Chromatography: Effects of Residence Time, Protein Concentration and Resin

Model-assisted process development, characterization and design of continuous chromatography for antibody separation

Evaluation of Dynamic Control of Continuous Capture with Periodic Counter-Current Chromatography under Feedstock Variations.

Converting a Mab Downstream Process from Batch to Continuous Using Process Modeling and Process Analytical Technology.

Model-based evaluation and model-free strategy for process development of three-column periodic counter-current chromatography

Model-assisted Approaches for Continuous Chromatography: Current Situation and Challenges.

Model-based Risk Assessment on Dynamic Control of Twin-Column Continuous Capture under Feedstock Variations

Analysis and Optimal Design of Batch and Two‐column Continuous Chromatographic Frontal Processes for Monoclonal Antibody Purification

Analysis and Optimal Design of Batch and Two-Column Continuous Chromatographic Frontal Processes for Monoclonal Antibody Purification

A Novel Twin‐column Continuous Chromatography Approach for Separation and Enrichment of Monoclonal Antibody Charge Variants

Process development and optimization of continuous capture with three‐column periodic counter‐current chromatography

High-throughput Screening and Optimization of Mixed-Mode Resins for Human Serum Albumin Separation with Microtiter Filter Plate

Comparison of Protein A affinity resins for twin-column continuous capture processes: Process performance and resin characteristics

A regressive approach to the design of continuous capture process with multi-column chromatography for monoclonal antibodies

Process Optimization and Economic Evaluation of Continuous Multi-Column Capture for Monoclonal Antibody – A Case Study

Continuous multi‐column capture of monoclonal antibodies with convective diffusive membrane adsorbers

Model-based process design of a ternary protein separation using multi-step gradient ion-exchange SMB chromatography

Evaluating end‐to‐end continuous antibody manufacture with column‐free capture alternatives from economic, environmental, and robustness perspectives